This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Wheel and Brake (Sand and Permanent Mold) Castings - Minimum Requirements for Aircraft Applications
- Aerospace Standard
Published January 05, 2005 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This SAE Aerospace Standard (AS) sets forth the minimum quality required for aircraft wheel and brake castings. Its use will establish minimum acceptable requirements for internal structure and surface conditions and is predicated on the use of a casting factor for the ultimate load of more than 1.51 through 2.00. When casting factors of 1.25 through 1.50 are used, visual, penetrant, and radiographic or other approved equivalent nondestructive inspection methods shall all be required on each production casting. Where specific parts, or areas of parts, require a quality level exceeding that described by this document, the requirements shall be established by negotiation between the purchaser and vendor.
|Ground Vehicle Standard||Automotive Gray Iron Castings|
|Aerospace Material Specification||Rings, Sealing, Cast Leaded-Tin Bronze 80Cu - 16Sn - 5Pb As Cast|
|Aerospace Material Specification||Silicone Rubber Sponge Closed Cell, Medium, Extreme Low Temperature|
Data Sets - Support Documents
|ASTME155||This document is not part of the subscrption.|
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.