This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Retainers (Back-Up Rings), Hydraulic and Pneumatic, Polytetrafluoroethylene Resin, Single Turn, Static Gland
- Aerospace Standard
Published April 12, 2006 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This Aerospace Standard (AS) covers scarf-cut polytetrafluoroethylene (PTFE) retainers (back-up rings) for use in static glands in accordance with AS5857. They are for use in hydraulic and pneumatic system components as anti-extrusion devices in conjunction with O-rings, packings and other elastomeric seals.
Because of the construction of groove dimensions, back-ups specific to rod applications are designated “R” - Rod (Female), back-ups specific to piston applications are designated “P” - Piston (Male).
Retainers specified herein have been designed for a temperature range of -65 °F to 275 °F (-54 °C to 135 °C) and a nominal operating pressure of 3000 psi (20.7 MPa) for code 09 material and 5000 psi (34.5 MPa) for code 10 material. Material codes are based on AMS 3678 material types.
Consideration has been made to accommodate cylinder breathing on piston applications, calculated at .002 inch/inch diameter/1,000 psi (.051 mm/mm diameter/6.9 MPa) to ensure a minimum 50% lap at -65 °F (-54 °C). This has required an increase in the diameter on certain larger sizes and a slight overlap at ambient will therefore be apparent. These parts have been designed such that the overlap at 275 °F (135 °C) will not result in axial compression of the O-rings, even in the worst tolerance stack-up situation.
This standard is required so that retainers (back-up) rings will be available for use with static glands per AS5857.
|Aerospace Standard||Retainers, (Back-Up Rings), Hydraulic and Pneumatic, Polytetrafluoroethylene Resin, Single Turn, Static Gland|
|Aerospace Material Specification||Rubber: Fluorosilicone (FVMQ) High Temperature Fuel and Oil Resistant For Seals In Fuel Systems and Specific Engine Oil Systems|
|Aerospace Material Specification||Synthetic Rubber and Cork Composition General Purpose Medium|
Data Sets - Support Documents
|Unnamed Dataset 1|
|TABLE 1A||MALE (PISTON) APPLICATIONS - DIMENSIONS IN INCHES AND DEGREES|
|TABLE 1B||FEMALE (ROD) APPLICATIONS - DIMENSIONS IN INCHES AND DEGREES|
|TABLE 2||SAMPLE SIZE|
A6C2 is responsible for the development of standards, processes, and practices related to Seals, Scrapers and Bearings used in actuation systems for Commercial and Military air vehicles. The panel provides a forum for government engineers, prime contractors, OEMs and suppliers to exchange technical information, regulatory updates, recent technology developments, issues related to system development and in service operation and lessons learned.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.