This content is not included in your SAE MOBILUS subscription, or you are not logged in.
- Aerospace Material Specification
Published September 14, 2006 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This specification covers a perfluoroether elastomer in the form of molded rings.
This standard was revised to clearly specify the test methods to be followed during aromatic fuel resistance testing. The original standard presented elongation and tensile strength release limits with the test procedure allowing a 30 minute conditioning at room temperature prior to property measurement after 70 hours soaking in the aromatic fuel. This was in error, and the test procedure followed should have specified, "immediate deteriorated properties", and followed testing instructions as defined in D-471, Procedure for change in Volume. This change in conditioning procedure results in a re-specification of the elongation and tensile strength release requirements. The paragraph for defining hydraulic fluid resistance testing was corrected to read AS1241. The hours required for long term compression set testing was omitted in the original AMS 7254 and Footnote 2 was added to specify the frequency at which the fluid is to be replaced during testing.
|Aerospace Material Specification||Perfluoroether Elastomer|
|Aerospace Material Specification||Tubing, Plastic, Electrical Insulation Irradiated Polyolefin, Pigmented, Flexible, Heat-Shrinkable 2 to 1 Shrink Ratio|
|Aerospace Material Specification||Tubing, Irradiated Polyolefin Plastic, Electrical Insulation Clear, Flexible, Heat Shrinkable, 2 to 1 Shrink Ratio|
Data Sets - Support Documents
|Unnamed Dataset 1|
|Unnamed Dataset 2|
|Unnamed Dataset 3|
|TABLE 2||ACCEPTANCE TESTS|
|TABLE 3||SUITABLE TEST SIZE|
Welcome to the AMS-CE Elastomers Committee Discussion Forum.The AMS-CE Elastomers Committee maintains Aerospace Materials Specifications (AMS), Aerospace Recommended Practices (ARP), Aerospace Information Reports (AIR) and Aerospace Standards (AS) on elastomeric materials. AMS-CE, which reports to the Aerospace Materials Division, coordinates and maintains liaison with industry, government and other standardization groups on elastomeric materials. A significant part of this committee is concerned with elastomeric fluid sealing materials, their applications, material development, testing, quality, design parameters and design practices. No copyrighted material may be posted in this forum. SAE is not liable for opinions expressed or information posted to this forum. All information posted becomes the property of SAE.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.