This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Polytetrafluoroethylene (PTFE) Film Non-Critical Grade
- Aerospace Material Specification
Published October 01, 1957 by SAE International in United States
This specification covers one grade of polytetrafluoroethylene (PTFE) resin in the form of film, normally produced by skiving. This film has been used typically for gaskets and other parts for use up to 260 degrees C (500 degrees F) where chemical resistance or anti-stick characteristics are required but where high mechanical or electrical characteristics are not important, but usage is not limited to such applications.
|Aerospace Material Specification||Fluid, Reference for Testing Di-Ester (Polyol) Resistant Material|
|Aerospace Material Specification||POLYTETRAFLUOROETHYLENE|
|Aerospace Material Specification||Polyamide-Imide Bar, Rod, and Shapes 30% Carbon Fiber|
Data Sets - Support Documents
No Datasets Available
Welcome to the AMS-P Polymeric & Composites Materials Committee discussion forum.The AMS-P Polymeric Materials Committee writes and revises Aerospace Material Specifications (AMS), Metric Aerospace Materials Specifications (MAM), Aerospace Recommended Practices (ARP), and Aerospace Information Reports (AIR) for composite material technology as assigned to the committee. No copyrighted material may be posted in this forum. SAE is not liable for opinions expressed or information posted to this forum. All information posted becomes the property of SAE.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.