This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Rubber, Silicone 1200 Psi (8.27 Mpa), High Modulus 45-55
- Aerospace Material Specification
Published April 01, 1967 by SAE International in United States
This specification covers a silicone rubber in the form of sheet, strip, tubing, extrusions and molded shapes. Primarily for parts required to operate or seal from -75 to +205 degrees C (-103 to +401 degrees F), compounded especially for high strength. Silicone elastomer is resistant to deterioration by weathering and by high-aniline-point-petroleum-base oils and remains flexible over the temperature range noted. These products are not normally suitable for use in contact with gasoline or aromatic fuels and low-aniline-point petroleum-base fluids due to excessive swelling.
Data Sets - Support Documents
No Datasets Available
Welcome to the AMS-CE Elastomers Committee Discussion Forum.The AMS-CE Elastomers Committee maintains Aerospace Materials Specifications (AMS), Aerospace Recommended Practices (ARP), Aerospace Information Reports (AIR) and Aerospace Standards (AS) on elastomeric materials. AMS-CE, which reports to the Aerospace Materials Division, coordinates and maintains liaison with industry, government and other standardization groups on elastomeric materials. A significant part of this committee is concerned with elastomeric fluid sealing materials, their applications, material development, testing, quality, design parameters and design practices. No copyrighted material may be posted in this forum. SAE is not liable for opinions expressed or information posted to this forum. All information posted becomes the property of SAE.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.