This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Polytetrafluoroethylene (PTFE) Resin Coating, High Build, 370-400°C (698-752°F) Fusion
- Aerospace Material Specification
Published January 01, 1963 by SAE International in United States
This specification establishes the engineering requirements for producing thick coatings of polytetrafluoroethylene (PTFE) resin on parts and the properties of such coatings. Primarily to provide dry lubrication, high heat stability, and corrosion protection on parts which operate at not higher than 275 degrees C (527 degrees F) for limited periods or not higher than 245 degrees C (473 degrees F) for extended periods. This coating may also be used as a release film for molds.
|Aerospace Material Specification||Polytetrafluoroethylene (PTFE) Resin Coating, Low Build, 370 to 400 °C (698 to 752 °F) Fusion|
|Aerospace Material Specification||Polytetrafluoroethylene (PTFE) Resin Coating, High Build, 370 to 400 °C (698 to 752 °F) Fusion|
|Aerospace Material Specification||Coating Material, Silicone Resin 400 °F (205 °C)|
Data Sets - Support Documents
No Datasets Available
Welcome to the AMS-P Polymeric & Composites Materials Committee discussion forum.The AMS-P Polymeric Materials Committee writes and revises Aerospace Material Specifications (AMS), Metric Aerospace Materials Specifications (MAM), Aerospace Recommended Practices (ARP), and Aerospace Information Reports (AIR) for composite material technology as assigned to the committee. No copyrighted material may be posted in this forum. SAE is not liable for opinions expressed or information posted to this forum. All information posted becomes the property of SAE.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.