This content is not included in your SAE MOBILUS subscription, or you are not logged in.
TEST PROCEDURES FOR EVALUATING BOLT-LOAD RETENTION OF MAGNESIUM ALLOYS
- Ground Vehicle Standard
Published November 19, 2020 by SAE International in United States
A bolt-load retention (BLR) test is a practical test to determine the bolt load of a fastener joint with time and at given temperatures. There are three types of BLR tests described in this standard, namely general-purpose test, design-purpose test, and screening material test. A general-purpose BLR test may be used for screening materials, while a design-purpose BLR test is usually used to verify the BLR behavior of a specific joint. The screening material test is an example of the general-purpose test for typical automotive applications.
Data Sets - Support Documents
No Datasets Available
|ASME B184.108.40.206M||This document is not part of the subscrption.|
|ASME B220.127.116.11M||This document is not part of the subscrption.|
|ASTM A563M||This document is not part of the subscrption.|
|ASTM F568||This document is not part of the subscrption.|
|ISO 4014||This document is not part of the subscrption.|
|ISO 4032||This document is not part of the subscrption.|
|ISO 898-1||This document is not part of the subscrption.|
|ISO 898-2||This document is not part of the subscrption.|
|J174_201304||Torque-Tension Test Procedure for Steel Threaded Fasteners - Inch Series|
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.