This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
RS704 Recommended Size and Location of Locking Wire Holes in Bolts, Screws and Nuts
- SAE ITC E&A Standard
- RS704-3
- Revised
Sector:
Issuing Committee:
Language:
English
Scope
No scope available.
Recommended Content
| Aerospace Standard | Bolts, Screws, and Studs, Screw Thread Requirements |
| Ground Vehicle Standard | Surface Discontinuities on General Application Bolts, Screws, and Studs |
| Ground Vehicle Standard | GRAIN FLOW PATTERN FOR BOLTS, SCREWS, AND STUDS |
Data Sets - Support Documents
No Datasets Available
Issuing Committee
Engine and Airframe Technical Standards Committee (TSC)
To act as the Design Authority for SAE-ITC in the development and ratification of SAE-ITC Standards and Specifications by consensus approval in a timely and cost effective manner. To develop and maintain an approved list of qualified manufacturers of SAE-ITC standard parts requiring qualification, to enable cost savings through greater usage and competition of supply.
Reference
| Number | Title |
|---|---|
| RS704 | This document is not part of the subscrption. |
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.