This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
SIX- AND TWELVE-VOLT CIGAR LIGHTER RECEPTACLES
- Ground Vehicle Standard
- J563_199003
- Reaffirmed
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Standard covers the basic cigar lighter receptacle, which may optionally incorporate overload protective devices.
Figure 1 and Table 1 show the cigar lighter receptacle and its pertinent dimensions.
Lighter plugs shall be permanently marked either "6 volt" or "12 volt".
Manufacturers of accessory plugs to energize devices such as trouble lamps and razors are cautioned to conform to the provisions given in this document.
Live contact of any accessory plug shall be made with the center stud; the contacting member must not be less than 3.56 mm in diameter and have a minimum spherical radius of 2.54 mm at the contacting end.
To prevent damage, the body of an accessory plug back of the contact end should be large enough to serve as a centering guide when it is inserted into the receptacle. The contact end of any accessory plug should have sufficient taper so as not to interfere with the receptacle bimetal fingers. Any ground contact fingers should be so designed as not to interfere with, distort, or catch on the grounding lances in the receptacle when the plug is rotated.
Wiring capacity and overload protection, as provided by the automotive industry to the 12 V lighter receptacle, restricts accessory plug devices to a maximum current draw of 8.0 A.
Accessory plugs shall be permanently marked "6 volt" or "12 volt" in letters 4.7 mm high minimum.
Data Sets - Support Documents
No Datasets Available
Issuing Committee
Circuit Protection and Switch Device Committee
The scope of the Circuit Protection & Switch Device Standards Committee includes the development and maintenance of standards and recommended practices of documents created by the following task forces: Circuit Protection Task Force J563 Cigarette Lighter & Power Outlet Task Force
Reference
Number | Title |
---|---|
ISO 16750-3 | This document is not part of the subscrption. |
ISO 16750-4 | This document is not part of the subscrption. |
ISO 9001 | This document is not part of the subscrption. |
J1887_201802 | Automotive Compacted Graphite Iron Castings |
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.