This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Parallel Side Splines for Soft Broached Holes in Fittings
- Ground Vehicle Standard
- J499_201406
- Stabilized
Downloadable datasets available
Annotation ability available
Sector:
Issuing Committee:
Language:
English
Scope
This Information Report along with SAE J500 and J501 is generally understood to be technically obsolete for the design of new applications. However, it is listed for those existing applications where it may be required. For the design of new applications, consult ANSI B92.1-1970—Involute Splines and Inspections Standard.
[The dimensions, given in inches, apply only to soft broached holes. The shaft dimensions depend upon the shape and material of the parts, their heat treatment, and methods of machining to give the required fit. The method and amount of "breaking" sharp corners and edges also depend upon the conditions and requirements of each application.
The formula for theoretical torque capacity (pressure on sides of spline) in inch-pounds per inch of bearing length (L) and at 1000 psi pressure is:
The tolerances allowed are for good construction and may be readily maintained by usual broaching methods. The tolerances selected for the large and small diameters will depend upon whether the fit between the mating parts, as finally made, is on the large or the small diameter. The other diameter, being designed for clearance may have a wider manufacturing tolerance. If the final fit between the parts is on only the sides of the spline, wider tolerances may be permitted on both the large and small diameters.]
Radii on corners of splines are not to exceed 0.015 in.
Splines shall not be more than 0.006 in per ft out of parallel with respect to the axis of the shaft.
No allowance is made for radii on corners or for clearance. Dimensions are intended to apply to only the soft broached hole. Allowance must be made for machining.
For values of D, W, d, h, and T for four-, six-, ten-, and sixteen-spline fittings, Table 2, Table 3, Table 4 and Table 5, respectively.
Rationale
This document has been determined to contain basic and stable technology which is not dynamic in nature. Expertise on this subject is no longer available.
Recommended Content
Ground Vehicle Standard | Shaft Ends |
Ground Vehicle Standard | Serrated Shaft Ends |
Aerospace Standard | NUT, SPANNER, BEARING RETAINING, AERONAUTICAL, UNS G41400 |
Data Sets - Support Documents
Title | Description | Download |
---|---|---|
TABLE 1 | W, H, AND D, IN TERMS OF LARGE DIAMETER, D | |
TABLE 2 | FOUR SPLINE FITTINGS | |
TABLE 3 | SIX SPLINE FITTINGS | |
TABLE 4 | TEN SPLINE FITTINGS | |
TABLE 5 | SIXTEEN SPLINE FITTINGS |
Issuing Committee
Materials, Processes and Parts Council
The Materials, Processes, and Parts Council (MPPC) promotes, directs, supervises and provides for the development of consensus SAE Technical reports. The council also conducts investigations for activities related to engineered materials, processes and parts used in the surface mobility industry. Participants in the SAE Materials, Processed and Parts Council include OEMs, suppliers, consulting firms, government and other interested parties.
Reference
Number | Title |
---|---|
ANSI/B 92.1 | This document is not part of the subscrption. |
J500 | This document is not part of the subscrption. |
J501_201406 | Shaft Ends |
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.