This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
MOTOR VEHICLE SEAT BELT ANCHORAGES—TEST PROCEDURE
- Ground Vehicle Standard
- J384_199406
- Revised
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Recommended Practice outlines the static test procedure for the evaluation of the performance of seat belt anchorages attached to vehicle structure or to seat assemblies installed in the vehicle. (This SAE Recommended Practice supersedes the Test Procedure Section of SAE J787b.) Design recommendations and performance requirements are specified in the Recommended Practices SAE J383 and SAE J385, respectively.
Recommended Content
Ground Vehicle Standard | Motor Vehicle Seat Belt Anchorages - Test Procedure |
Technical Paper | Evaluation of Neck Bracket Angles and Neck Torque Procedures in the Hybrid III Small Female Neck Flexion Test |
Data Sets - Support Documents
No Datasets Available
Issuing Committee
Seat Belt Systems Standards Committee
SCOPE: Provide a forum for volunteer experts in the field of safety belts to assist in the review and update of current SAE safety belt standards applicable to new passenger cars and multipurpose passenger vehicles and light duty trucks. SHORT TERM OBJECTIVES: 1. Identify SAE safety belt standards that require revision; 2. Establish extent of revision (low, medium, high); 3. Prioritize and establish timeframe for completion. LONG TERM OBJECTIVES: Identify and create new SAE safety belt standards
Reference
Number | Title |
---|---|
J383_201303 | Motor Vehicle Seat Belt Anchorages - Design Recommendations |
J383_201410 | Motor Vehicle Seat Belt Anchorages - Design Recommendations |
J385_201303 | Motor Vehicle Seat Belt Anchorages - Performance Requirements |
J385_201407 | Motor Vehicle Seat Belt Anchorages - Performance Requirements |
J879 | This document is not part of the subscrption. |
J879B_201910 | Motor Vehicle Seating Systems |
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.