This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Highly Accelerated Failure Test (HAFT) for Automotive Lamps with LED Assembly
- Ground Vehicle Standard
- J3014_201303
- Issued
Downloadable datasets available
Annotation ability available
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Recommended Practice provides test procedures, requirements, and equipment recommendations for the methods of the measurement that characterizes potential design failures by utilizing a step stress approach to subject a device under test to thermal, vibration, and electrical stresses of types and levels beyond what it may see in actual use, but which will rapidly induce failure modes, allowing them to be detected and corrected.
Rationale
Highly accelerated failure test (HAFT), or sometimes referred as accelerated life test (ALT) or highly accelerated life test (HALT) has been an industry's practice for long period time, both in automotive lighting as well as in general lighting applications. The purpose of HALT is to identify defined failures that may relate to the "weakest link", quality or design faults, or claimed life of the products. With fast growth of LED sources being used in the lighting applications, the lumen maintenance alone may not be the measure of reliability. Other types of failures, within the LED lamp assembly, must be identified as a quality or reliability concern. HAFT is intended to identify LED lamp assembly failure modes; the test results do not and should not be used to predict operational life of the product. For practical reasons, the HAFT should be completed within a one-day period.
With all possible impact from environment and usage in automotive applications, it is identified based on the known best practice in the industry that three major stressors can be used to induce earlier failures. These stressors are temperature, vibration, and input voltage to LED source assembly. This test is used to realize the operating and destructive limits of a product, when subjected to thermal, electrical and vibration loads.
Humidity is not considered as an independent stressor because it is a function of temperature and the formation of condensation naturally occurs as temperatures are lowered. Controlling humidity requires air exchange and conditioning. Controlling humidity during temperature changes is slow and mechanically challenging. During rapid thermal transitions it is not possible to control humidity. The HAFT test will produce rapid uncontrolled humidity swings as temperature changes and will be a stressor on the DUT, but it will not be specified as a variable in the test.
The analysis of the test results may also help recognize variations and uncover factors that may affect the intended performance. The sequences or combinations of applied stressors to the DUT are recommended based on the current practices.
Recommended Content
| Ground Vehicle Standard | Highly Accelerated Failure Test (HAFT) for Automotive Lamps with LED Assembly |
| Ground Vehicle Standard | Automotive Starter Remanufacturing Procedures |
| Ground Vehicle Standard | FIELD CORRELATED LIFE TEST SUPPLEMENT TO SAE/USCAR-2 |
Topic
Data Sets - Support Documents
| Title | Description | Download |
|---|---|---|
| Unnamed Dataset 1 |
Issuing Committee
Test Methods and Equipment Stds Committee
The Test Methods and Equipment Standards Committee is part of the Lighting Systems Steering Committee that reports to the Motor Vehicle Council (MVC).
Reference
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.