This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Brake Adjustment Limit for Air Brake Actuators
- Ground Vehicle Standard
- J2899_201312
- Issued
Downloadable datasets available
Annotation ability available
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Recommended Practice applies to S-CAM, Wedge, and Disc air brake actuators where the stroke can be measured without disassembly from the brake.
Rationale
Field inspections to determine if air brakes on commercial vehicles are in an out-of-service condition are excessively complicated. Current method requires measurement of the air brake actuator diameter to determine the air brake actuator size. A standard rated stroke for the air brake actuator size is then assumed unless a marking is found on the air brake actuator or ID tag that indicates a different rated stroke. Using the determined rated stroke and chamber size, a chart is referenced to provide the brake adjustment limit. The inspector then confirms through measurement that the air brake actuator stroke is less than the determined brake adjustment limit.
This method has many potential sources for error. A given actuator size may have several rated stroke options available. Charts converting air brake actuator diameters are not accurately maintained. Air brake actuator diameters are not accurately measured. Air brake actuator manufacturers do not have standardized ID tag nomenclature making it difficult to read the rated stroke. Air brake actuators can be covered in paint or road debris hiding rated stroke information. Stroke rating clamp tags require clamps to mount to and must be located in a clamp clocking that is accessible to the inspector.
This process can be simplified because the brake adjustment limit is a function of the rated stroke only. By putting a standardized rated stroke marking on the air brake actuator in a known location, the only conversion required is between the rated stroke marking to the brake adjustment limit. This document provides this recommended practice, reducing the likelihood of an inspector passing a vehicle that should be out of service or putting a vehicle out of service that is within acceptable operating conditions.
This new recommended practice also provides air brake actuator outside diameters developed from manufacturer’s data for reference to support air brake actuators manufactured prior to this recommended practice. The SAE Truck and Bus Brake Actuator Committee have the largest representation of air brake actuator manufacturers making it the ideal source for such information.
If this document gets adopted, SAE J1817 will be revised to identify long stroke air brake actuator markings only to avoid overlap.
Recommended Content
Ground Vehicle Standard | Air Brake Actuator Test Procedure, Truck-Tractor, Bus, and Trailers |
Ground Vehicle Standard | Truck and Bus Grade Parking Performance Requirements |
Data Sets - Support Documents
Title | Description | Download |
---|---|---|
Unnamed Dataset 1 |
Issuing Committee
Truck and Bus Brake Actuator Committee
The Truck and Bus Brake Actuator Committee of the Truck and Bus Brake and Advanced Driver Assistance Systems Steering Committee is responsible for developing, reviewing, and approving recommended practices, standards, and information reports related to air brake actuators and their interfacing as used on trucks, tractor-trailer combinations and buses over 10,000 lbs (4500 Kg) GVWR designed primarily for highway use.
Reference
Number | Title |
---|---|
J1469_201702 | Air Brake Actuator Test Procedure, Truck-Tractor, Bus, and Trailers |
J1817_201603 | Long-Stroke Air-Brake Actuator Marking |
J1953_201805 | Brake-Stroke Indicator Design Guideline for Cam or Disc Air-Brake Actuators |
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.