This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Agricultural Tractor Test Code (Oecd)
- Ground Vehicle Standard
Published April 01, 1993 by SAE International in United States
The purpose of this SAE standard is to define test conditions, describe tests to be made, specify data to be obtained, show formulas and calculations, define terms, and establish a uniform method of reporting so that performance data obtained on various makes and models of tractors, tested in accordance with this document, will be comparable regardless of where the tests are made. Because of the availability of many tractor models and types that can be equipped with a variety of special or optional equipment, the scope of this standard must be limited to obtaining and reporting only the most significant of widely used performance data. Test performed to either the Standard Code as outline in Section 4 or the Restricted Coed as outlined in Section 5 will satisfy requirements of this Agricultural Tractor Test Code. This document is technically equivalent to the OECD Tractor Test Code C(87)53, Annex I and Annex II. It is intended as a guide to development and pre-testing of tractors prior to official OECD testing. It is not, however, a replacement for the official codes used by OECD test stations, and any questions or conflicts concerning official OECD testing should be resolved by consulting the official OECD codes of the OECD Coordinating Center in Paris.Coordinating Center in Paris.
Data Sets - Support Documents
No Datasets Available
|IECNo.651||This document is not part of the subscrption.|
|ISO3448||This document is not part of the subscrption.|
|ISO4251/1||This document is not part of the subscrption.|
|ISO730/1||This document is not part of the subscrption.|
|ISO730/2||This document is not part of the subscrption.|
|ISO730/3||This document is not part of the subscrption.|
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.