This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Lift Capacity Calculation Method Scrap and Material Handlers
- Ground Vehicle Standard
- J2518_201207
- Revised
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Standard provides a uniform method to calculate the lift capacity of scrap and material handlers, establishes definitions and specifies machine conditions for the calculations. This document applies to scrap and material handlers as defined in SAE J2506 that have a 360 degrees continuous rotating upper structure. It does not apply to equipment that is incapable of lifting a load completely off the ground. This document applies to those machines that are crawler, wheel, rail and pedestal or stationary mounted.
Rationale
Paragraph 4.1.4 incompletely addresses the orientation and position of oscillating axles and did not address steering axles for lift capacity calculations.
Recommended Content
| Technical Paper | Universal Depot Inspection System: A Diagnostic Dynamometer Controller |
| Technical Paper | An Improved Multipurpose Grease For Automotive Applications |
Data Sets - Support Documents
No Datasets Available
Issuing Committee
MTC SC5 is responsible for standards related to hydraulic excavators, as defined by ISO 6165. A hydraulic excavator is a self-propelled machine on crawlers, wheels, or legs, having an upper structure normally capable of a 360-degree swing with mounted equipment (primarily for excavating with a bucket) without moving the undercarriage during the work cycle.
Reference
| Number | Title |
|---|---|
| ASMEB30.25 | This document is not part of the subscrption. |
| ISO10567 | This document is not part of the subscrption. |
| J2417_201410 | Lift Capacity Calculation Method Knuckle-Boom Log Loaders and Certain Forestry Equipment |
| J2506_201904 | Material Handler Nomenclature and Specifications |
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.