SAE No. 2 Friction Test Machine Durability Test
- Ground Vehicle Standard
This document has been declared "Stabilized" and will no longer be subjected to periodic reviews for currency. Users are responsible for verifying references and continued suitability or technical requirements. New technology may exist.
This SAE Recommended Practice is intended as the definition of a standard test, but may be subject to frequent change to keep pace with experience and technical advances. This should be kept in mind when considering its use.
The SAE No 2 Friction Test Machine is used to evaluate the friction characteristics of automatic transmission plate clutches with automotive transmission fluids. It can also be used to conduct durability tests on wet friction systems.
The specific purpose of this document is to define a Durability Test based on a specific power level selected from either the 3600 r/min Stepped Power Test or from the 6000 r/min Stepped Power Test, for the evaluation of wet friction system performance variation as a function of number of cycles. This standard procedure is intended for common use by both suppliers and end users to allow objective comparisons of wet friction material system performance.
The only variables selected by the supplier or user of the friction system are: a. Friction Material; b. Fluid; and c. Reaction Plates.
These three variables must be clearly identified when reporting the results of this test. If any of the test parameters or system hardware as described in this document are changed, other than the friction material, test fluid, or reaction plates, the data may not be reported as having been obtained using this document.
This procedure is not intended to evaluate the initial coefficient or break-in characteristics. For this information, refer to SAE J2490 SAE No. 2 Friction Test Machine μPVT Test.
|Technical Paper||Development of the Fuel Saving Low Viscosity ATF|
|Technical Paper||Development of Real World Driving Cycle for Vehicle Durability Evaluation|
|Technical Paper||THE NEW MOTORS AMERICAN V-8 ENGINE|
Data Sets - Support Documents
The Automatic Transmission Friction Standards Committee reports to the Powertrain Systems Group of the Motor Vehicle Council. The Committee is responsible for developing and maintaining SAE Standards, Recommended Practices, and Information Reports related to bench performance evaluation of wet friction systems (friction materials, reaction surfaces and fluids) as used in power-shift torque transfer elements. These elements may function as ratio changing clutches and/or bands, torque converter lockup clutches, launch/start clutches and disconnect clutches depending on the application within a given driveline design. Participants in the SAE Automatic Transmission Friction Standards Committee include OEMs, suppliers, consulting firms, government, and other interested parties.
|J1499||This document is not part of the subscrption.|
|J1499_201203||SAE Band Friction Test Machine Guidelines|
|J1646||This document is not part of the subscrption.|
|J1646_201203||Glossary of Terms - Lubricated Friction Systems|
|J2487_201205||SAE No. 2 Friction Test Machine 3600 r/min Stepped Power Test|
|J2487_201905||SAE No. 2 Friction Test Machine 3600 rpm Stepped Power Test|
|J2488_201303||SAE No.2 Friction Test Machine 6000 r/min Stepped Power Test|
|J2488_201907||SAE No. 2 Friction Test Machine 6000 rpm Stepped Power Test|
|J2490_201208||SAE No. 2 Friction Test Machine µPVT Test|
|J2490_201905||SAE No. 2 Friction Test Machine μPVT Test|
|J286||This document is not part of the subscrption.|
|J286_201203||SAE No. 2 Clutch Friction Test Machine Guidelines|