This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Categorization and Properties of Dent Resistant, High Strength, and Ultra High Strength Automotive Sheet Steel
- Ground Vehicle Standard
- J2340_199910
- Issued
Downloadable datasets available
Annotation ability available
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Recommended Practice defines and establishes mechanical property ranges for seven grades of continuously cast high strength automotive sheet steels that can be formed, welded, assembled, and painted in automotive manufacturing processes. The grade of steel specified for an identified part should be based on part requirements (configuration and strength) as well as formability. Material selection should also take into consideration the amount of strain induced by forming and the impact strain has on the strength achieved in the finished part. These steels can be specified as hot-rolled sheet, cold-reduced sheet, uncoated, or coated by hot dipping, electroplating, or vapor deposition of zinc, aluminum, and organic compounds normally applied by coil coating. The grades and strength levels are achieved through chemical composition and special processing. Not all combinations of strength and coating types may be commercially available. Consult your steel supplier for details.
Recommended Content
| Ground Vehicle Standard | Categorization and Properties of Dent Resistant, High Strength, and Ultra High Strength Automotive Sheet Steel |
| Aerospace Standard | SLEEVE, COUPLING, FLARELESS |
Topic
Data Sets - Support Documents
| Title | Description | Download |
|---|---|---|
| TABLE 1 | STEELS AND STRENGTH GRADES | |
| TABLE 2 | PRODUCT CHARACTERISTICS OF HOT-ROLLED SAE J2340 STEEL | |
| TABLE 3 | REQUIRED MINIMUM MECHANICAL PROPERTIES OF DENT RESISTANT SHEET STEEL | |
| TABLE 4 | REQUIRED MECHANICAL PROPERTIES OF HIGH STRENGTH AND HSLA HOT-ROLLED AND COLD-REDUCED UNCOATED AND COATED SHEET STEEL | |
| TABLE 5 | REQUIRED MECHANICAL PROPERTIES OF HIGH STRENGTH RECOVERY ANNEALED COLD-REDUCED SHEET STEEL | |
| TABLE 6 | REQUIRED MECHANICAL PROPERTIES OF ULTRA HIGH STRENGTH DUAL PHASE HOT-ROLLED AND COLD-REDUCED SHEET STEEL | |
| TABLE 7 | REQUIRED MECHANICAL PROPERTIES OF LOW CARBON MARTINSITE HOT-ROLLED AND COLD-REDUCED SHEET STEEL | |
| TABLE 8 | CHEMICAL LIMITS ON UNSPECIFIED ELEMENTS | |
| TABLE 9 | TENSILE MACHINE OPERATING PARAMETERS | |
| TABLE A1 | TYPICAL MECHANICAL PROPERTIES OF DENT RESISTANT COLD-REDUCED SHEET STEEL | |
| TABLE A2 | TYPICAL MECHANICAL PROPERTIES OF ULTRA HIGH STRENGTH DUAL PHASE HOT-ROLLED AND COLD-REDUCED SHEET STEEL | |
| TABLE A3 | TYPICAL MECHANICAL PROPERTIES OF ULTRA HIGH STRENGTH LOW CARBON MARTENSITE COLD-REDUCED SHEET STEEL | |
| TABLE A4 | TYPICAL INSIDE BEND RADII HIGH STRENGTH AND HSLA, COLD-REDUCED AND HOT-ROLLED AND HIGH STRENGTH RECOVERY ANNEALED COLD-REDUCED UNCOATED AND COATED SHEET STEEL |
Issuing Committee
Reference
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.