This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Connections for On-Board Road Vehicle Electrical Wiring Harnesses Part 2: Tests and General Performance Requirements
- Ground Vehicle Standard
Published October 28, 2003 by SAE International in United States
This SAE Standard defines tests methods and general performance requirements of single-pole and multiple connectors for on-board electrical wiring harnesses of road vehicles. These requirements are not intended for connections internal to electronic devices. This document applies to connectors designed to be disconnected after mounting in the vehicle in the case of repair and/or maintenance.
|Magazine Issue||Automotive Engineering International 2012-03-20|
|Magazine Issue||MOMENTUM: APRIL 2018|
|Technical Paper||ROAD TRACTORS|
Data Sets - Support Documents
No Datasets Available
Electrical Distribution Steering Committee
The scope of the Electrical Distribution Systems Steering Committee includes the development and maintenance of standards and recommended practices for automotive power and signal distribution systems used in passenger cars and light duty trucks. The scope includes standards for wiring systems, connection systems, cable, and harness coverings. Standards are developed for all voltage ratings up to but not including ignition cable assemblies and components. The scope does not include circuit protection or switching devices.
|ASTMB117||This document is not part of the subscrption.|
|IECPUBLICATION5||This document is not part of the subscrption.|
|ISO6722/3||This document is not part of the subscrption.|
|ISO6722/4||This document is not part of the subscrption.|
|ISO8092/2||This document is not part of the subscrption.|
|ISO9227||This document is not part of the subscrption.|
|J1128_201310||Low Voltage Primary Cable|
|J1213/1||This document is not part of the subscrption.|
|J1560||This document is not part of the subscrption.|
|J2183||This document is not part of the subscrption.|
|J2223-1||This document is not part of the subscrption.|
|J2223-3||This document is not part of the subscrption.|
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.