This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Road Vehicles - Wheels for Commercial Vehicles and Multipurpose Passenger Vehicles - Fixing Nuts - Test Methods
- Ground Vehicle Standard
- J1965_201710
- Revised
Downloadable datasets available
Annotation ability available
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Recommended Practice applies to fasteners/fixing nuts as specified in SAE J694 and SAE J1835 used for disc wheels and demountable rim attachment respectively.
Only the test methods necessary to ensure proper wheel or rim assembly are specified. Fasteners for less common and special applications are not included.
Rationale
This revised recommended practice improves the testing conditions for retorque. The number of retorques was reduced back to the original five times since data presented showed the loss of tension occurs in the first five retorques and is relatively stable after five retorques. The retorque testing causes heat to be generated which is not representative of reinstallation of nuts in the field. Data was submitted that following the original procedure for the first four retorques of 1 minute dwell and then allowing the nut body to cool to 60 to 80 °F for the 5th retorque gave the same results as waiting for cool down after each retorque. The lubrication which was optional is now standardized. The temperature measurement location of the middle of the hex of the nut was found to be the best location and also easy to measure. It is shown in Figure 2. We added the M18 ball seat nut to proof load Table 1 as it is used in medium trucks.
Recommended Content
Technical Paper | An Innovative Solution to Assembly Conical Roller Bearings on Wheel Hubs |
Ground Vehicle Standard | Automotive Starter Solenoid Remanufacturing Procedures |
Ground Vehicle Standard | Outboard Mounted Brake Drum/Disc Wheel Hub Interface Dimensions - Truck and Bus |
Topic
Data Sets - Support Documents
Title | Description | Download |
---|---|---|
Unnamed Dataset 1 | ||
Unnamed Dataset 2 | ||
Table 1 | Proof load values | |
Table 2 | Test torques and tensions | |
Unnamed Dataset 5 |
Issuing Committee
The responsibility of the Truck and Bus Wheel Committee of the Truck and Bus Brake and Advanced Driver Assistance Systems Steering Committee is to initiate, develop, review and approve the recommended practices, standards, and information reports related to hubs, wheels and the wheel mounting systems of buses, trucks and tractor-trailer combinations intended for highway use. The Wheel Committee is constituted so as to be aware of other SAE wheel activity and to prevent duplication of effort.
Reference
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.