This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
ABS Excitor Ring Location Standardization
- Ground Vehicle Standard
- J1730_200407
- Revised
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Recommended Practice establishes the Antilock Brake System [ABS] sensor interface and envelope dimensions for standardizing the location of the ABS rings mounted on the inner end of the hub on the following axle designations.
-
a
FF
-
b
FL
-
c
L
-
d
R
-
e
U
-
f
W
-
g
N
-
h
P
Data Sets - Support Documents
No Datasets Available
Issuing Committee
The responsibility of the Truck and Bus Wheel Committee of the Truck and Bus Brake and Advanced Driver Assistance Systems Steering Committee is to initiate, develop, review and approve the recommended practices, standards, and information reports related to hubs, wheels and the wheel mounting systems of buses, trucks and tractor-trailer combinations intended for highway use. The Wheel Committee is constituted so as to be aware of other SAE wheel activity and to prevent duplication of effort.
Reference
Number | Title |
---|---|
J1842_201402 | Disc Wheel Hub/Spoke Wheel and Axle Interface Dimensions - Truck and Bus |
J2246_201404 | Antilock Brake System Review |
J2475_201407 | Wheel End Assembly and Axle Spindle Interface Dimensions - Truck and Bus |
J2535_201910 | Setting Preload in Heavy-Duty Wheel Bearings |
J393_201710 | Nomenclature - Wheels, Hubs, and Rims for Commercial Vehicles |
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.