This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Connections for Fluid Power and General Use-Hydraulic Couplings-Diagnostic
- Ground Vehicle Standard
Published April 01, 1997 by SAE International in United States
SAE J1052 specifies dimensions, performance requirements, and test procedures for the male half of a diagnostic coupler with either a metric M14x1.5 or an inch 9/16-18 straight thread stud end. The coupler is designed for use with a mineral based hydraulid fluid. It is used on machines specified in SAE J1116. It does not apply to the mating hydraulic quick action couplings not on the machine. Diagnostic couplings in accordance with this part of ISO may be used at a working pressure of 41.4 MPa (414 bar). The permissible working pressure depends upon the materials, design, working conditions, application, etc. Conformance to the dimensional information in this part of SAE J1502 does not guarantee rated performance. Each manufacturer should perform testing according to the specification contained in this document to ensure that components comply with the performance rating.
|Technical Paper||PNEUMATIC SYSTEMS AND DEVICES FOR AUTOMOBILES|
|Ground Vehicle Standard||Brake Master Cylinder Reservoir Diaphragm Gasket|
|Aerospace Standard||Aerospace - Design and Installation of Commercial Transport Aircraft Hydraulic Systems|
Data Sets - Support Documents
No Datasets Available
Hydraulic Tube Fittings Committee
The Hydraulic Tube Fittings Subcommittee of the FCCTC develops and maintains SAE Standards, Recommended Practices and Information Reports relating to hydraulic and pneumatic tube fittings for all fluid power applications except hydraulic and pneumatic brake applications Participants in the FCCTC Hydraulic Tube Fittings Subcommittee include OEMs, suppliers, consulting firms, government and other interested parties.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.