This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
SEAT BELT HARDWARE PERFORMANCE REQUIREMENTS
- Ground Vehicle Standard
- J141_199506
- Revised
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Recommended Practice describes performance requirements for hardware used in motor vehicle seat belt assemblies when tested in accordance with the test procedures specified in SAE J140.
Test procedures and performance requirements for retractors will be covered in separate SAE Recommended Practices to be issued later.
Recommended Content
Ground Vehicle Standard | Seat Belt Hardware Test Procedures |
Ground Vehicle Standard | Seat Belt Restraint System Hardware - Glossary of Terms |
Technical Paper | NBS Dynamic Seat Belt Tester |
Data Sets - Support Documents
No Datasets Available
Issuing Committee
Seat Belt Systems Standards Committee
SCOPE: Provide a forum for volunteer experts in the field of safety belts to assist in the review and update of current SAE safety belt standards applicable to new passenger cars and multipurpose passenger vehicles and light duty trucks. SHORT TERM OBJECTIVES: 1. Identify SAE safety belt standards that require revision; 2. Establish extent of revision (low, medium, high); 3. Prioritize and establish timeframe for completion. LONG TERM OBJECTIVES: Identify and create new SAE safety belt standards
Reference
Number | Title |
---|---|
J114 | This document is not part of the subscrption. |
J114_201306 | Seat Belt Hardware Webbing Abrasion Performance Requirements |
J140_201302 | Seat Belt Hardware Test Procedures |
J339 | This document is not part of the subscrption. |
J339_201306 | Seat Belt Hardware Webbing Abrasion Test Procedure |
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.