This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
HELICAL COMPRESSION AND EXTENSION SPRING TERMINOLOGY
- Ground Vehicle Standard
- J1121_198807
- Revised
Sector:
Issuing Committee:
Language:
English
Scope
The following recommended practice has been developed to assist engineers and designers in the preparation of specifications for the major types of helical compression and extension springs. It is restricted to a concise presentation of items which will promote an adequate understanding between spring manufacturer and spring user of the major practical requirements in the finished spring. Closer tolerances are obtainable where greater accuracy is required and the increased cost is justified.
For the basic concepts underlying the spring design and for many of the details, see the SAE Information Report MANUAL ON DESIGN AND APPLICATION OF HELICAL AND SPIRAL SPRINGS, SAE HS J795, which is available from SAE Headquarters in Warrendale, PA 15096. A uniform method for specifying design information is shown in the TYPICAL DESIGN CHECK LISTS FOR HELICAL SPRINGS, SAE J1122.
Two types of helical springs are considered:
-
a
Hot coiled compression springs for general automotive use as well as for motor vehicle suspensions.
-
b
Cold wound compression and extension springs for general automotive use.
This recommended practice uses SI (metric) units in accordance with the provisions of SAE J916 JUN82.
Recommended Content
Technical Paper | LEAF SPRINGS |
Technical Paper | INFLUENCES AFFECTING THE FUNDAMENTAL DEFLECTION OF LEAF SPRINGS |
Technical Paper | SPRING DESIGN |
Topic
Data Sets - Support Documents
No Datasets Available
Issuing Committee
The SAE Coil Spring Sub-Committee is responsible for the review and updating of standards, information reports and recommended practices appropriate to manuals relating to the design and application of coil springs used in the transportation industry. One of our main thrusts is to update the SAE Spring Coil Manual HS-795 with the latest developments in coil spring technology.
Reference
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.