This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Standard Sheet Steel Thickness and Tolerances
- Ground Vehicle Standard
Published December 21, 1999 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This SAE Recommended Practice provides an orderly series for designating the thickness of unocated and coated hot-rolled and cold-rolled sheet and strip. This document also provides methods for specifying thickness tolerances.
This document was revised by the SAE Iron and Steel Technical Committee Division 32—Sheet and Strip Steel. The contents of SAE J446 was merged into SAE J1058.
|Aerospace Standard||Reference Standards Notched Shims for Magnetic Particle Inspection|
|Aerospace Material Specification||Piston Rings, Centrifugally-Case Alloyed Iron 0.50Mo - 0.50Cu|
|Aerospace Material Specification||Carbon Steel, Wire and Springs 0.75 - 0.88C (SAE 1080) Spring Temper, Cold Drawn|
Data Sets - Support Documents
|TABLE 1||(METRIC)—PREFERRED THICKNESS AND THICKNESS TOLERANCES OF UNCOATED OR COATED STEEL SHEET WITH COLD-ROLLED OR HOT-ROLLED SUBSTRATES IN WIDTHS TO 1850 mm|
|[Unnamed Dataset 2]|
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.