This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Wheel and Brake (Sand and Permanent Mold) Castings - Minimum Requirements for Aircraft Applications
- Aerospace Standard
- AS586A
- Reaffirmed
Downloadable datasets available
Annotation ability available
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Aerospace Standard (AS) sets forth the minimum quality required for aircraft wheel and brake castings. Its use will establish minimum acceptable requirements for internal structure and surface conditions and is predicated on the use of a casting factor for the ultimate load of more than 1.51 through 2.00. When casting factors of 1.25 through 1.50 are used, visual, penetrant, and radiographic or other approved equivalent nondestructive inspection methods shall all be required on each production casting. Where specific parts, or areas of parts, require a quality level exceeding that described by this document, the requirements shall be established by negotiation between the purchaser and vendor.
Recommended Content
| Aerospace Material Specification | Steel Castings, Investment, Corrosion Resistant 19.5Cr - 10.5Ni - 0.25S (Type 303) Solution Heat Treated |
| Aerospace Material Specification | Castings, Leaded Bronze, Sand and Centrifugal 80Cu - 10Sn - 9.5Pb As Cast |
| Aerospace Material Specification | Steel Castings, Investment, Corrosion Resistant 18Cr - 9Ni Solution Heat Treated |
Topic
Data Sets - Support Documents
| Title | Description | Download |
|---|---|---|
| TABLE 1 | ||
| TABLE 2 |
Issuing Committee
Reference
| Number | Title |
|---|---|
| ASTME155 | This document is not part of the subscrption. |
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.