This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Counterfeit Electrical, Electronic, and Electromechanical (EEE) Parts; Avoidance, Detection, Mitigation, and Disposition
- Aerospace Standard
Published March 26, 2019 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This standard is for use by organizations that procure and/or integrate and/or repair EEE parts and/or assemblies containing such items, including maintenance, repair, and overhaul (MRO) organizations. The requirements of this standard are generic and intended to be applied/flowed down, as applicable, through the supply chain, to all organizations that procure EEE parts and/or assemblies, regardless of type, size, and product provided. The mitigation of counterfeit EEE parts in this standard is risk-based, and these mitigation steps will vary depending on the criticality of the application, desired performance, and reliability of the equipment/hardware.
The requirements of this document are intended to be used in conjunction with a higher-level quality standard (e.g., AS/EN/JISQ9100, ISO-9001, ANSI/ASQC E4, ASME NQA-1, AS9120, AS9003, and ISO/TS 16949 or equivalent) and other quality management system documents. They are not intended to stand alone, supersede, or cancel requirements found in other quality management system documents, requirements imposed by contracting authorities, or applicable laws and regulations unless an authorized exemption/variance has been obtained. This document is not intended to make a legal determination of fraud, and appropriate legal counsel should be consulted for further action.
This Standard was created and is being updated in response to continually evolving, significant, and increasing risk of counterfeit electrical, electronic, and electromechanical (EEE) parts entering the aerospace supply chain, posing significant performance, reliability, and safety risks.
Data Sets - Support Documents
|[Unnamed Dataset 1]|
|[Unnamed Dataset 2]|
|[Unnamed Dataset 3]|
|[Unnamed Dataset 4]|
|[Unnamed Dataset 5]|
|[Unnamed Dataset 6]|
|[Unnamed Dataset 7]|
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.