This content is not included in your SAE MOBILUS subscription, or you are not logged in.
PIN, EXPANSION - ALUMINUM, 2024-T4, LONG
- Aerospace Standard
Published June 27, 2007 by SAE International in United States
Downloadable datasets availableAnnotation ability available
THIS DOCUMENT HAS BEEN REAFFIRMED TO COMPLY WITH THE SAE 5-YEAR REVIEW POLICY.
MATERIAL: AMS 4120 (AL ALLOY 2024-T4).
FINISH: MIL-C-5541 (CHEMICAL FILM) DYED YELLOW.
PINS ARE PREWAXED TO AID DRIVING.
SURFACE TEXTURE: SYMBOLS PER ANSI Y14.36-1978, REQUIREMENTS PER ANSI B46.1-1978. UNLESS OTHERWISE SPECIFIED, SURFACES TO BE 250 MICROINCHES Ra.
BREAK EDGES .003-.015 UNLESS OTHERWISE SPECIFIED.
DIMENSIONS IN INCHES. UNLESS OTHERWISE SPECIFIED, TOLERANCE : ANGULAR DIMENSIONS ± 2°. DIMENSIONS APPLY AFTER FINISH.
MARK PART NUMBER AND MANUFACTURER'S IDENTIFICATION ON PACKAGE.
USE WITH AS3121 PLUGS. SEE AIR 3277 INSTALLATION PROCEDURES.
DIMENSIONING AND TOLERANCING: ANSI Y14.5-1973.
DO NOT USE UNASSIGNED PART NUMBERS.
APPROVED SOURCE OF SUPPLY:
THE LEE CO
FEDERAL SUPPLY CODE FOR MANUFACTURER'S NO 92555.
ONLY THE ITEM DESCRIBED ON THIS DRAWING WHEN PROCURED FROM THE VENDOR LISTED HEREON IS APPROVED FOR USE IN THE APPLICATIONS SPECIFYING THIS AEROSPACE STANDARD IDENTIFICATION NUMBER. A SUBSTITUTE ITEM SHALL NOT BE USED WITHOUT PRIOR TESTING AND APPROVAL BY THE DESIGN ACTIVITY RESPONSIBLE FOR THE APPLICATION.
IDENTIFICATION OF THE APPROVED SOURCE HEREON IS NOT TO BE CONSTRUED AS A GUARANTEE OF PRESENT OR CONTINUED AVAILABILITY AS A SOURCE OF SUPPLY FOR THE ITEM DESCRIBED ON THE DRAWING.
|Aerospace Standard||PIN, EXPANSION - ALUMINUM, 2024-T4 AND 2024-T351, SHORT, UNS A92024|
|Aerospace Standard||FITTING, SLEEVE, FLARED|
Data Sets - Support Documents
|Unnamed Dataset 1|
E-25 General Standards for Aerospace and Propulsion Systems
The SAE E-25 General Standards for Aerospace & Propulsion Systems committee addresses aerospace propulsion systems and components. These systems and components include bolts, screws, nuts, washers, studs, rivets, pins, covers, O-rings, brackets, plugs and associated procurement requirements, as well as solid film lubricants and design specifications for screw threads and fastener assembly requirements.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.