This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
SEAL, PLAIN, RUBBER (-65 TO +350 °F FUEL RESISTANT) MOLD IN GROOVE
- Aerospace Standard
- AS27198A
- Revised
Downloadable datasets available
Annotation ability available
Sector:
Issuing Committee:
Language:
English
Rationale
WHEN MS27198 WAS CONVERTED TO AS27198 THE PLATE MATERIAL WAS UPDATED FROM MIL-S-5059 302 ANNEALED TO AMS 5515. MIL-S-5059 CANCELLATION NOTICE 1 STATES THAT 302 ANNEALED WAS REPLACED BY AMS 5516. THIS REVISION CORRECTS THAT ERROR.
-
MATERIAL: METAL RETAINER, CORROSION RESISTANT STEEL, SPEC AMS 5516 RUBBER SEAL, RUBBER PER SPEC AMS-R-25988, MOLDED SHAPE FORM -
REMOVE ALL BURRS AND SHARP EDGES.
-
DIMENSIONS IN INCHES. UNLESS OTHERWISE SPECIFIED, TOLERANCES: DECIMALS ±.005; FRACTIONS ±1/64; ANGLES ±1/2°.
-
INDIVIDUALLY PACKAGE PER SPEC MIL-STD-2073-1, METHOD 33.
-
PRODUCT SHALL BE PERMANENTLY IDENTIFIED AS TO MANUFACTURER AND TYPE.
-
SEAL DESIGN MUST PROVIDE SUBSTANTIAL FILLING OF THE GROOVE WHEN ASSEMBLED.
-
FOR DESIGN FEATURE PURPOSES, THIS STANDARD TAKES PRECEDENCE OVER PROCUREMENT DOCUMENTS REFERENCED HEREIN.
-
REFERENCED DOCUMENTS SHALL BE OF THE ISSUE IN EFFECT ON THE DATE OF INVITATIONS FOR BID.
-
A CHANGE BAR ( | ) LOCATED IN THE LEFT MARGIN IS FOR THE CONVENIENCE OF THE USER IN LOCATING AREAS WHERE TECHNICAL REVISIONS, NOT EDITORIAL CHANGES, HAVE BEEN MADE TO THE PREVIOUS ISSUE OF THIS DOCUMENT. AN (R) SYMBOL TO THE LEFT OF THE DOCUMENT TITLE INDICATES A COMPLETE REVISION OF THE DOCUMENT, INCLUDING TECHNICAL REVISIONS. CHANGE BARS AND (R) ARE NOT USED IN ORIGINAL PUBLICATIONS, NOR IN DOCUMENTS THAT CONTAIN EDITORIAL CHANGES ONLY.
Recommended Content
| Aerospace Standard | SEAL, BONDED, 302 CORROSION RESISTANT STEEL, AMS5516, MOLD IN GROOVE, SILICONE RUBBER, AMS7268 |
| Aerospace Material Specification | Rubber: Fluorocarbon (FKM) High Temperature/Fluid Resistant Low Compression Set/85 to 95 Hardness For Seals In Fuel Systems and Specific Engine Oil Systems |
| Aerospace Material Specification | Elastomer: Silicone, Rubber (MQ/VMQ) General Purpose 55 - 65 Durometer Type "A" Hardness |
Topic
Data Sets - Support Documents
| Title | Description | Download |
|---|---|---|
| TABLE 1 | ||
| Unnamed Dataset 2 |
Issuing Committee
A6C2 is responsible for the development of standards, processes, and practices related to Seals, Scrapers and Bearings used in actuation systems for Commercial and Military air vehicles. The panel provides a forum for government engineers, prime contractors, OEMs and suppliers to exchange technical information, regulatory updates, recent technology developments, issues related to system development and in service operation and lessons learned.
Reference
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.