This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
STUD - STRAIGHT, DRILLED, STEEL (SAE 8740), CADMIUM PLATED, .3750-16UNS X .3750-24UNF-3A
- Aerospace Standard
- AS129293B
- Revised
Downloadable datasets available
This content contains a 2D/3D
configurator
Annotation ability available
Sector:
Issuing Committee:
Language:
English
Rationale
GENERAL REVISION. FIGURE 1 RE-DRAWN, REVISE THREADS FROM MIL-S-7742 TO ASME B1.1 AND IDENTIFY ØC AS MAJOR DIAMETER, ADD DATUM B FOR NUT END THREAD, UPDATE DRILLED HOLE CALLOUT AND ADD POSITION REQUIREMENT, REVISE MARKING TO AS478 METHOD 2, UPDATE MPI REFERENCE, ADD NEW NOTE FOR DISPOSITION OF EXISTING INVENTORY, MINOR EDITORIAL UPDATES.
Recommended Content
Topic
2D/3D Drawings
Some older browsers could require a plugin
install for 3D and or 2D previewer.
Data Sets - Support Documents
Title | Description | Download |
---|---|---|
TABLE 1 | DIMENSIONS |
Issuing Committee
E-25 General Standards for Aerospace and Propulsion Systems
The SAE E-25 General Standards for Aerospace & Propulsion Systems committee addresses aerospace propulsion systems and components. These systems and components include bolts, screws, nuts, washers, studs, rivets, pins, covers, O-rings, brackets, plugs and associated procurement requirements, as well as solid film lubricants and design specifications for screw threads and fastener assembly requirements.
Reference
Number | Title |
---|---|
AMS2400 | Cadmium Plating |
AMS6322 | Steel Bars, Forgings, and Rings, 0.50Cr - 0.55Ni - 0.25Mo (0.38 - 0.43C) (SAE 8740) |
ANSI Y14.5M | This document is not part of the subscrption. |
AS7456 | Studs, Steel, Low Alloy Heat Treated, Roll Threaded |
ASME B46.1 | This document is not part of the subscrption. |
ASME Y14.36M | This document is not part of the subscrption. |
ASTME1444 | This document is not part of the subscrption. |
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.