Drawing Interpretation and Standard Machining Practices, Couplings, Fittings and Hose Ends, Fluid Systems
- Aerospace Standard
- ARP4296B
- Cancelled
Scope
This SAE Aerospace Recommended Practice (ARP) is intended to interpret and clarify engineering drawing requirements relating to the manufacture and inspection of fluid system couplings, tube fittings, and hose ends. Because it is impractical to define every minute detail of the part on the face of the drawing, this document describes interpretations of dimensioning of general machining features and otherwise undefined tolerances that fall under the heading of "good shop practice". This document serves as a supplement to engineering drawings when referenced on applicable documents.
Rationale
Recommended Content
Aerospace Standard | FITTING END, STANDARD DIMENSIONS FOR BULKHEAD FLARELESS TUBE CONNECTIONS |
Aerospace Standard | Across Hex Corner Dimension for Fluid Fittings and Nuts |
Data Sets - Support Documents
Issuing Committee
G-3, Aerospace Couplings, Fittings, Hose, Tubing Assemblies
This Committee is responsible for developing and maintaining standards for design, test, and procurement of fluid systems part standards to improve reliability and economy. Their primary focus is on AS standards development and support of military standards. The Committee also develops ISO standards in a Subcommittee Advisory Group (SCAG) to ISO/TC 20/SC 10, and SAE-MA derivatives thereof.
Structure: SAE G-3 -- Parent committee SAE G-3A -- Aerospace Couplings Subcommittee SAE G-3B -- Aerospace Fittings Subcommittee SAE G-3D -- Aerospace Hose Subcommittee SAE G-3E - Aerospace Tubing Assemblies Subcommittee U.S. SCAG to ISO/TC 20/SC 10 -- ISO standards Major projects: Support of Military Standards Reform Support of military standard conversions to MIL-PERF and MIL-DTL. Development of AS replacements for military standards designated for conversion. Establish document to list G-3 accepted replacements for replaced part standards and military back-up specifications. Development of PRI QML/QPL Development of Performance Review Institute (PRI) process for approval and surveillance of manufacturers (Qualified Manufacturer List, QML) and for approval of standard parts as qualified for use (Qualified Parts List, QPL). Development of ISO Standards, Imperial Units ISO/TC 20/SC 10 standards have typically been developed in SI units. The ISO has approved development of inch-based ISO standards to support commercial aviation. Basic design, test, and procurement specifications will be selected from military standards that are to be converted to Non-Government standard (NGS) and developed as ISO standards.Reference
Number | Title |
---|---|
ANSI/Y14.5M | This document is not part of the subscrption. |
ARP4266 | Hole Contour, Fluid Passage, Tube Fitting |
ARP4784 | PERFORMANCE AND EVALUATION CRITERIA, SURFACE DEFECTS, REQUIREMENTS FOR |