This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Aircraft Turbine Engine Pneumatic Component Contaminated Air Endurance Test
- Aerospace Standard
- ARP4014
- Reaffirmed
Sector:
Issuing Committee:
Language:
English
Scope
This recommended practice describes a method of conducting an endurance test using contaminated air when the applicable specification requires non-recirculation of the contaminants. The objective of the test is to determine the resistance of the engine mounted components to wear or damage caused by the contaminated air.
The method described herein calls for non-recirculation of the contaminants and is intended to provide a uniform distribution of the contaminant at the inlet to the Unit Under Test (UUT).
The UUT may require the use of a hydraulic fluid for actuation of components within the test unit. Contamination of this test fluid is not part of this recommended practice, however, if required by applicable test specification, refer to MAP 749A.
Rationale
ARP4014 has been reaffirmed to comply with the SAE five-year review policy.
Recommended Content
Aerospace Standard | Turbofan and Turbojet Gas Turbine Engine Test Cell Correlation |
Ground Vehicle Standard | Test Method for Measuring Performance of Engine Cooling Fans |
Aerospace Standard | Aircraft/Engine Fuel Pump Two Phase (Slugging Flow) Inlet Performance Test and Evaluation |
Topic
Data Sets - Support Documents
No Datasets Available
Issuing Committee
AC-9 Aircraft Environmental Systems Committee
Furthers the advancement of technology related to the research, design, test and utilization of aircraft environmental and anti-icing/deicing systems. Develops and updates standards, recommended practices, and information reports contributing to the quality, economy, and safety of commercial and military aircraft.
Reference
Number | Title |
---|---|
MAP749 | This document is not part of the subscrption. |
MIL-E-5007 | This document is not part of the subscrption. |
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.