This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Plastic Sheets, Rods and Tubing, Rigid Cast, Methacrylate (Multiapplication)
- Aerospace Material Specification
Published August 25, 2011 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This specification covers methacrylate sheets, rods and tubes produced by casting or machining cast blanks. This specification does not apply to heat-formed and molded or extruded shapes, or shapes made by assembling two or more pieces.
This document has been determined to contain basic and stable technology which is not dynamic in nature.
|Aerospace Standard||Wiring, Positioning, and Support Accessories|
|Aerospace Material Specification||Rubber, Chlorosulfonated Polyethylene Elastomer, Sheet and Molded Shapes, Ozone Resistant|
|Aerospace Material Specification||Silicone Rubber 1000 psi (6.89 MPa) Minimum Tensile Strength 45 - 55 Durometer|
Data Sets - Support Documents
|[Unnamed Dataset 1]|
|[Unnamed Dataset 2]|
|TABLE 1||Property values for cast sheets|
|TABLE II||Property values for cast rods and tubes|
|TABLE III||Nominal thickness and tolerances for grade A (preshrunk) cell cast sheets|
|TABLE IV||Nominal thickness and tolerance for grades B and C cell cast sheets|
|TABLE V||Nominal thickness, length, and tolerances for Grades B and C continuous cast sheeting|
|TABLE VI||Nominal diameter and tolerances of cast rods|
|TABLE VII||Nominal outside diameter and tolerance of cast tubes|
|TABLE VIII||Nominal wall thickness and tolerances of cast tubes|
|TABLE IX||Heating conditions for determining stability of optical clarity of rods|
|TABLE X||Examination of sheets, rods, and tubes for defects in appearance and workmanship|
|TABLE XI||Examination of sheets, rods, and tubes for dimensional defects|
|TABLE XII||Examination for defects in preparation for delivery|
|[Unnamed Dataset 15]|
|TABLE XIII||Heating time for shrinkage test|
|[Unnamed Dataset 17]|
|TABLE XIV||Classification in this document and corresponding classification in L-P-391C|
Welcome to the AMS-P Polymeric & Composites Materials Committee discussion forum.The AMS-P Polymeric Materials Committee writes and revises Aerospace Material Specifications (AMS), Metric Aerospace Materials Specifications (MAM), Aerospace Recommended Practices (ARP), and Aerospace Information Reports (AIR) for composite material technology as assigned to the committee. No copyrighted material may be posted in this forum. SAE is not liable for opinions expressed or information posted to this forum. All information posted becomes the property of SAE.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.