This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Vulcanized Fiber Sheet
- Aerospace Material Specification
Published November 07, 2011 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This specification covers vulcanized fiber in the form of sheet.
This document has been determined to contain basic and stable technology which is not dynamic in nature.
|Aerospace Material Specification||Sponge, Fluorosilicone (FVM) Rubber Closed Cell|
|Aerospace Material Specification||Steel Castings, Sand, Corrosion and Moderate Heat Resistant 13Cr Normalized and Tempered|
Data Sets - Support Documents
|TABLE 2A||Minimum Tensile Strength, Inch/Pound Units|
|TABLE 2B||Minimum Tensile Strength, SI Units|
|TABLE 3||Maximum Water Absorption|
|TABLE 4||Minimum Density|
|TABLE 5A||Tolerances, Inch/Pound Units|
|TABLE 5B||Tolerances, SI Units|
|TABLE 6||Acceptance Tests|
Welcome to the AMS-P Polymeric & Composites Materials Committee discussion forum.The AMS-P Polymeric Materials Committee writes and revises Aerospace Material Specifications (AMS), Metric Aerospace Materials Specifications (MAM), Aerospace Recommended Practices (ARP), and Aerospace Information Reports (AIR) for composite material technology as assigned to the committee. No copyrighted material may be posted in this forum. SAE is not liable for opinions expressed or information posted to this forum. All information posted becomes the property of SAE.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.