This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Landing Gear Manufacturing, Maintenance, Repair, and Overhaul Critical Processes
- Aerospace Standard
Published May 09, 2022 by SAE International in United States
CPs are a process that is executed on a critical landing gear (or undercarriage) part, assembly or equipment that if performed incorrectly or omitted would cause:
An operational failure of the aircraft; or
An unacceptable risk of injury
This document identifies CPs that have either caused operational failure or that can be reasonably expected to cause operational failures based on experience. Note that in the interest of brevity, that this document is not intended to be a definitive listing, only an introduction and a consideration of common processes.
This SAE Aerospace Information Report (AIR) provides guidelines and useful references for Critical Processes (CPs) and related lessons learned for structural landing gear systems for an aircraft. It is intended as information only, and should not be used as a mandatory requirement specification.
Data Sets - Support Documents
No Datasets Available
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.