This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Fluid-System-Component Specification Preparation Criteria
- Aerospace Standard
Published October 04, 2013 by SAE International in United States
Downloadable datasets availableAnnotation ability available
The importance of adequate component procurement specifications to the success of a hardware development program cannot be overemphasized. Specifications which are too stringent can be as detrimental as specifications which are too lax. Performance specifications must not only identify all of the component requirements, but they must also include sufficient quality assurance provisions so that compliance can be verified. It should be understood that in almost every case specifications for components will ultimately become part of a BINDING, WRITTEN CONTRACT (PO).
The purpose of this document is to describe types of specifications, provide guidance for the preparation of fluid component specifications, and identify documents commonly referenced in fluid component specifications.
The document as written does not represent a safety or health issue which per document rules disallow cancellation. The value of an updated AIR1082B would be limited because ARP4754 was recently updated and offers guidance on specifying fuel system and equipment and MIL-STD-461e already offers guidance on specification format and production. This document will, therefore, be stabilized.
|Aerospace Material Specification||Colors Used in Government Procurement|
|Aerospace Standard||Style Manual for Standards and Other Publications of TechAmerica|
|Aerospace Standard||CRIMPING TOOLS, TYPE 2, TERMINAL, HAND, WIRE TERMINATION, FOR COAXIAL, TWINAXIAL, TRIAXIAL, SHIELDED CONTACTS AND FERRULES, TERMINAL LUGS, SPLICES, AND END CAPS|
Data Sets - Support Documents
|[Unnamed Dataset 1]|
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.