This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Spectral IR Images of Direct-Injection Diesel Combustion by High-Pressure Fuel Injection
ISSN: 0148-7191, e-ISSN: 2688-3627
Published February 01, 1995 by SAE International in United States
Annotation ability available
Instantaneous successive spectral infrared (IR) images were obtained from a spray plume in a direct injection (DI) type compression-ignition (CI) engine during the compression and combustion periods. The engine equipped with a high pressure electronic-controlled fuel injector system was operated by using D-2 Diesel fuel.
In the new imaging system used for the present study, four high-speed IR cameras (with respective band filters in front) were lined up to a single optical arrangement containing three spectral beam splitters to obtain four spectral images at once. Two band filters were used for imaging the water vapor distribution and another two band filters were placed for capturing images of combustion chamber wall or soot formation.
The simultaneous imaging was successively triggered by signals from an encoder connected to the engine. The fuel injection parameters were precisely controlled and the pressure-time (p-t) history was obtained for individual sets of images. The start of fuel injection was varied through four different crank angle positions.
Mentioning some results from the study, the spectral IR images had no resemblance with the ones obtained using a visible-range camera from a comparable engine system as reported by others. In general, the present spectral images taken at the same crank angle were not mutually comparable.
A highly unexpected phenomenon was observed in the study, i.e., the images recorded during the ignition delay period exhibit some strong preflame reactions over the fuel spray plume. The preflame reactions appear to have started immediately after the fuel injection. This newly observed phenomenon is interpreted to represent strong chemiluminescence seemingly followed by exothermic reactions. The heat release during the ignition delay period is expected to be offset by the latent heat of evaporation to cause no measurable change in p-t history compared with the same measured from a hot-motoring condition.
CitationClasen, E., Campbell, S., and Rhee, K., "Spectral IR Images of Direct-Injection Diesel Combustion by High-Pressure Fuel Injection," SAE Technical Paper 950605, 1995, https://doi.org/10.4271/950605.
- Jiang, H. McComiskey, T. Qian, Y. Jeong, Y.I. Rhee, K.T. Kent J.C. “A New High-Speed Spectral Infrared Imaging Device Applied for Imaging Gaseous Mixtures from Combustion Devices,” Combustion Science and Technology 90 5-6 341 1993
- McComiskey, T. Jiang, H. Qian, Y. Rhee, K.T. Kent. J.C. “High-Speed Spectral Infrared Imaging of Spark Ignition Engine Combustion,” SAE Paper- 930865 1993
- Jiang, H. Qian, Y. Rhee, K.T. “High-Speed Dual-Spectra Infrared Imaging,” Optical Engineering 32 6 1281 1289 1993
- Jeong, Y.I. Qian, Y. Campbell, S. Rhee, K.T. “Investigation of a Direct Injection Diesel Engine by High-Speed Spectral IR Imaging and KIVA-II,” SAE Paper- 941732 1994
- Ludwig, C.B. Malkmus, W. Reardon, J.E. Thomson, J.A.L. Handbook of Infrared Radiation from Combustion Gases NASA SP-3080 1973
- Abata, D. Stroia, B.J. Beck, N.J. Roach, A.R. “Diesel Engine Flame Photographs with High Pressure Injection,” SAE Paper- 880298 1988
- Gaydon, A.G. Wolfhard, H.D. Flames, Their structure, radiation and temperature Chapman and Hall, Ltd. London 1970