This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Exhaust Emissions and Combustion Stability in a Bi-Fuel Spark Ignition Engine
Annotation ability available
Sector:
Language:
English
Abstract
A Saturn 1.9 liter engine has been converted for operation on either compressed natural gas or gasoline. A bi-fuel controller (BFC) that uses closed-loop control methods for both fuel delivery and spark advance has been developed. The performance and emissions during operation on each fuel have been investigated with the BFC, as well as the performance and emissions with the stock original equipment manufacturer (OEM) controller using gasoline. In-cylinder pressure was measured at a rate of 1024 points per revolution with piezoelectric pressure transducers flush-mounted in the cylinder head. The in-cylinder pressure was used in real time for ignition timing control purposes, and was stored by a data acquisition system for the investigation of engine stability and differences in the combustion properties of the fuels. Engine-out emissions of hydrocarbons (HC), oxides of nitrogen (NOx), carbon dioxide (CO2), and carbon monoxide (CO) were also recorded along with other relevant engine performance data. Ignition delays, combustion durations and statistical cycle-to-cycle variations were calculated from the in-cylinder pressure traces and compared between the two fuels and different control methods. Ignition delay, defined as the time between the spark and when the in-cylinder pressure deviates significantly from a motoring curve, was shorter for CNG than for gasoline. Combustion duration, defined as the time between when 10% and 90% of the mass fraction is burned, was longer for CNG than for gasoline. Engine stability, as measured by the coefficient of variance of the gross indicated mean effective pressure [COV(IMEPg)], was better with the BFC than the stock controller. NOx emissions were found to decrease as engine stability improved. Emissions of HC, CO, and CO2 were less dependent on engine stability than they were on other parameters such as fuel type and equivalence ratio. It is the goal of this research to produce an optimized bi-fuel engine and add to the body of knowledge on the differences in combustion between CNG and gasoline.
Recommended Content
Authors
Topic
Citation
Atkinson, C., Traver, M., Tennant, C., Atkinson, R. et al., "Exhaust Emissions and Combustion Stability in a Bi-Fuel Spark Ignition Engine," SAE Technical Paper 950468, 1995, https://doi.org/10.4271/950468.Also In
References
- Weaver, C.E. Santavicca, D.A. “Correlation of Cycle-Resolved Flame Kernel Growth and Cylinder Pressure in an Optically-Accessible Engine” SAE Paper No. 922171 1992
- Heywood, J.B. Internal Combustion Engine Fundamentals McGraw-Hill New York, NY 1988
- Young, M.B. “Cyclic Dispersion in the Homogenous-Charge Spark-Ignition Engine---A Literature Survey” SAE Paper No. 810020 1981
- Patterson, D.J. “Cylinder Pressure Variations, A Fundamental Combustion Problem” SAE Paper No. 660129 1966
- Matekunas, F.A. “Modes and Measures of Cyclic Combustion Variability” SAE Paper No. 830337 1983
- Chanchaona, S. McFeaters, J.S. Raine, R.R. “Effects of High Compression Ratio and Combustion Chamber Shape on Cycle-to-Cycle Variability” SAE Paper No. 900385 1990
- Weaver, C.S. “Natural Gas Vehicles -- A Review of the State of the Art” SAE Paper No. 892133 1989
- Ozdor, N. Dulger, M. Sher, E. “Cyclic Variability in Spark Ignition Engines: A Literature Survey” SAE Paper No. 940987 1994
- Martin, J.K. Plee, S.L. Remboski, D.L Jr., “Burn Modes and Prior-Cycle Effects on Cyclic Variations in Lean-Burn Spark-Ignition Engine Combustion” SAE Paper No. 880201 1988
- Kalghatgi, G.T. “Spark Ignition, Early Flame Development and Cyclic Variation in I.C. Engines” SAE Paper No. 870163 1987
- Bates, S.C. “Flame Imaging Studies of Cycle-by-Cycle Combustion Variation in a SI Four-Stroke Engine” SAE Paper No. 892086 1989
- Thring, R.H. “The Effect of Varying Combustion Rate in Spark Ignition Engines” SAE Paper No. 790387 1979
- Young, M.B. “Cyclic Dispersion - Some Quantitative Cause-and-Effect Relationships” SAE Paper No. 800459 1980
- Jääskeläinen, H.E. Wallace, J.S. “Performance and Emissions of a Natural Gas-Fueled 16 Valve DOHC Four-Cylinder Engine” SAE Paper No. 930380 1993
- Varde, K.S. Cherng, J.C. Bailey, C.J. Majewski, W.A. “Emissions and Their Control in Natural Gas Fueled Engines” SAE Paper No. 922250 1992
- Tennant, C.L deJong, R.D. Atkinson, R.J. Traver, M.L. Atkinson, C.M. Vincent, C.L Clark N.N. Lyons, D.W. “Performance of a High Speed Engine with Dual Fuel Capability” SAE Paper No. 940517 1994
- Atkinson, R.L Tennant, C.L Traver, M.L. Atkinson, C.M. Clark, N.N. “Control and Efficiencies of a Spark Ignition Engine with Dual Fuel Capability” SAE Paper No. 942004 1994
- Lancaster, D.R. Krieger, R.B. Lienesch, J.H. “Measurement and Analysis of Engine Pressure Data” SAE Paper No. 750026 1975
- Randolph, A.L. “Methods of Processing Cylinder-Pressure Transducer Signals to Maximize Data Accuracy” SAE Paper No. 900170 1990
- Brunt, M.F. Lucas, G.G. “The Effect of Crank Angle Resolution on Cylinder Pressure Analysis” SAE Paper No. 910041 1991
- Traver, M.L. “An Analysis of In-Cylinder Pressure Histories in a Bi-Fuel Engine” West Virginia University 1994