This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Variable Orifice Geometry Verified on the Two-Phase Nozzle (VRD)
Annotation ability available
Sector:
Language:
English
Abstract
Innovative solutions for reducing particulate emissions will be necessary in order to comply with the even more stringent exhaust-gas standards of the future.
The potential of a diesel nozzle with variable orifice geometry has long been common knowledge in the area of engine construction. But up to now, a fully functional solution of such a nozzle has not appeared which operates with a reduced orifice at low engine speeds and/or low loads. Here with regard to target costing, the requirements implicit in function and manufacture must also be taken into account.
Using calculations on nozzle interior flow and injection-spray investigations, it will be shown which nozzle geometries best fulfill the various requirements. In order to achieve low levels of particulate emission in an engine with a combustion chamber designed for optimum use of a hole-type nozzle, the injection-spray direction and its geometry must to a large extent correspond to those of a hole-type nozzle. This is decisive for the two-phase nozzle (VRD) to make full use of its potential in a conventional combustion chamber.
The two-phase nozzle with spray orifices arranged directly above one another provides the solution to this problem.
The spray geometry for the variable-orifice nozzle has been realised. The application of the needle control for the FTP75 test procedure is being worked on.
Recommended Content
Authors
Citation
Potz, D., Kreh, A., and Warga, ., "Variable Orifice Geometry Verified on the Two-Phase Nozzle (VRD)," SAE Technical Paper 950081, 1995, https://doi.org/10.4271/950081.Also In
References
- (Development of diesel injection technology. A technical and economical challenge) 93
- Chmela Werlberger Cartellieri Parameters affecting in-cylinder soot and NO x formation in a direct-injection diesel engine I Mech E 1992
- Prescher Binder (Spray dispersion and mixture formation in diesel engines using unconventional direct injection) 1992 310 346
- Dürnholz Hermann (The potential of 4-valve technology in the passenger-car engine using direct injection) 93
- Wünsche Wojik (AVL Leader. The new passenger-car diesel generation, designed for low emissions) 1993
- Sczomak The poppet covered orifice fuel injection nozzle SAE Paper 900821