This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Dimethyl Ether as a Methanol Ignition Improver: Substitution Requirements and Exhaust Emissions Impact
Annotation ability available
Sector:
Language:
English
Abstract
Methanol is one of the leading alternatives to diesel fuel and gasoline. In Diesel applications methanol's low cetane number has necessitated the use of glowplugs, spark plugs or expensive additives for ignition assistance.
This paper reports on the use of Dimethyl Ether (DME) as an ignition improver for neat methanol in a compression ignition engine. Gaseous DME was admitted to the intake air stream of a four stroke test engine operating on directly injected methanol. The amount of DME required to achieve stable operation over the load/speed range of the engine without the use of a glow plug was determined. DME's effect on ignition delay and rate of pressure rise is discussed. Exhaust emissions were measured and compared with operation on methanol with glow plug assisted ignition. Hydrocarbon emissions were reduced by a factor of 10 at light loads. Aldehyde emissions were also reduced.
Recommended Content
Topic
Citation
Green, C., Cockshutt, N., and King, L., "Dimethyl Ether as a Methanol Ignition Improver: Substitution Requirements and Exhaust Emissions Impact," SAE Technical Paper 902155, 1990, https://doi.org/10.4271/902155.Also In
References
- Bennethum J.E. Srinivasan N. “Detroit Diesel Allison's Two Stroke Cycle Compression Ignited Alcohol Engines” International Symposium On Alcohol Fuels Technology, Proceedings 1984 Ottawa, Ontario
- Brook D. L. Rallis C.J. Lane N.W. Cipolat D. “Methanol With Dimethyl Ether Ignition Promotor as a Fuel for Compression Ignition Engines” SAE Paper 849083
- Kozole K.H. Wallace J.S. “The Use of Dimethyl Ether as a Starting Aid for Methanol-Fueled SI Engines at Low Temperatures” SAE Paper 881677
- Onishi S. Hong Jo S. Shoda K. Do Jo P. Kato S. “Active Thermo-Atmosphere Combustion (ATAC)- A New Combustion Process for Internal Combustion Engines” SAE Paper 790501
- Siebers D. L. Edwards C.F. Auto Ignition of Methanol and Ethanol Sprays Under Diesel Engine Conditions” SAE Paper 870588
- Karpuk M.E. Cowley S.W. “On Board Dimethyl Ether Generation to Assist Methanol Engine Cold Starting” SAE Paper 881678