This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Onboard Diagnosis of Engine Misfires
Annotation ability available
Sector:
Language:
English
Abstract
The integrity of the exhaust emission system in a passenger vehicle can best be maintained by monitoring its performance continuously on board the vehicle. It is with the intent of monitoring emission system performance that the California Air Resources Board has proposed regulations which will require vehicles to be equipped with on-board monitoring systems. These proposed regulations are known as OBDII and will probably be followed by similar Federal EPA regulations.This paper discusses a method of monitoring engine misfire as part of the OBDII requirements for passenger vehicle on-board diagnostics. The method is relatively inexpensive in that it uses an existing sensor for measuring instantaneous crankshaft angular position, and utilizes electronic signal processing which can be implemented in relatively inexpensive custom integrated circuits. Our experimental results, obtained over nearly a decade, indicate that the performance of the proposed misfire detection system is sufficient to detect extremely low levels of engine misfire, thus effectively protecting the health of the emissions control system.
Recommended Content
Technical Paper | Fault Diagnostics for Internal Combustion Engines - Current and Future Techniques |
Technical Paper | Analysis of Particulate Matter Sensor Signals |
Technical Paper | Drivability Improvements on Electronic Diesel Engines |
Authors
Topic
Citation
Ribbens, W. and Rizzoni, G., "Onboard Diagnosis of Engine Misfires," SAE Technical Paper 901768, 1990, https://doi.org/10.4271/901768.Also In
References
- Ribbens W.B. “A non-contacting torque sensor for the IC engine” SAE paper no. 810155, presented at the 1981 SAE International Congress and Exposition, Detroit, MI, February 1981.
- Taplin “Lean limit internal combustion engine roughness control system”, U.S Patent # 3,789,816, Feb. 1974.
- Leung and Schira “A Digital Engine Analyzer” SAE paper no. 820207, presented at the 1982 SAE International Congress and Exposition, Detroit, MI, February 1982.
- Ribbens W.B. “A new metric for torque nonuniformity”, SAE paper no. 830425, presented at the 1983 SAE International Congress and Exposition, Detroit, MI, February 1983.
- Mihelc W., Citron S. “An online engine roughness measurement technique”, SAE paper no. 840136, presented at the 1984 SAE International Congress and Exposition, Detroit, MI, February 1984.
- Ribbens, W.B., Experimental road test of a noncontacting method of measuring IC engine torque nonuniformity”, SAE paper no. 840454, presented at 1985 SAE Int'l Congress and Exposition, Detroit MI, February, 1985.
- Freestone J. W., Jenkins E.G., “The diagnosis of cylinder power faults in diesel engines by flywheel speed measurement” IEE paper #C33/85, 1985
- Citron S., Mihelc W. 1985 “Engine performance monito and control system” US patent number 4,532, 592, July 30th, 1985
- Ribbens W.B. “Experimental road test of a noncontacting method of measuring IC engine torque nonuniformity” SAE paper no. 850454, presented at the 1985 SAE International Congress and Exposition, Detroit, MI, February 1985.
- Ribbens W.B., Gross D. “Torque nonuniformity measurements in gasoline fueled passenger cars equipped with automatic transmission - theory and experimental results”, SAE paper no. 860414, presented at the 1986 SAE International Congress and Exposition, Detroit, MI, February 1986.
- Rizzoni G. “A model for the dynamics of the internal combustion engine” PhD dissertation, Department of Electrical and Computer Engineering, the University of Michigan, Ann Arbor MI, February 1986.
- Ribbens W.B., “Driveline control system”, U.S. Paten #4606005, August 12, 1986.
- Rezeka S.F., Henein N.A. “A diagnostic technique for the identification of.misfiring cylinder(s)” SAE paper no. 870546, presented at the 1987 SAE International Congress and Exposition, Detroit, MI, February 1987.
- Rizzoni G., “A Passenger Vehicle On-board Computer System for Engine Fault Diagnosis, Performance Measurement and Control,” in Proc. of 37th IEEE Veh. Technol. Conf., pp. 450-457, Tampa, FL, June 1987.
- Rizzoni G., “Estimate of indicated torque from crankshaft speed fluctuations: a model for the dynamics of the IC engine”, presented at XXVII International Symposium on Automotive Technology and Automation, Florence, Italy, June, 1987.
- Citron S., “Online engine torque and torque fluctuation measurement for engine control utilizing engine crankshaft speed fluctuations”, US patent # 4,697,561, Oct. 1987.
- Rizzoni “Fast transforms.for rapid isolation of misfiring cylinders” SAE paper no. 871915 presented at SAE Passenger Car Meeting, October, 1987.
- Ribbens W.B., Naaseh M. “Incipient failure detection in bus engine components”, SAE paper no. 872264 presented at SAE Truck and Bus Meeting, November 1987.
- Rizzoni G., Pipe J. G., Riggins R. N., Van Oyen M. P., “Fault Isolation and Analysis for IC Engine Onboard Diagnostics,” Proc. of IEEE Veh. Technol. Conf., Philadelphia, PA, June 1988.
- Rizzoni G., “Diagnosis of Individual Cylinder Misfires by Signature Analysis of Crankshaft Speed Fluctuations” SAE paper 890884 presented at SAE Int'l Congress and Exposition, February, 1989.
- O'Higgins J., Citron S., Chen L. Y. “Cylinder by cylinder engine pressure torque waveform determination utilizing crankshaft speed fluctuations”, SAE paper no. 890486, in SAE SP 771, Sensors and Actuators, presented at SAE Int'l Congress and Exposition, Detroit, MI, February 1989.
- Citron S., O'Higgins J., “Cylinder by cylinder engine pressure torque waveform determination utilizing crankshaft speed fluctuations”, US patent # 4,843,870, July 4th, 1989.
- Rizzoni G., “Estimate of indicated torque from crankshaft speed fluctuations: a model for the dynamics of the IC engine”, in IEEE Trans. Veh. Technol., Vol VT-38, no.3, August 1989.