This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Model to Predict Hydraulic Pump Requirements for an Off-Road Vehicle
Annotation ability available
Sector:
Language:
English
Abstract
This paper describes and discusses a computer model that can be used to predict the hydraulic pump requirements of an excavator necessary to meet the specified productivity levels for a given set of design conditions. The model predicts the hydraulic cylinder flow rates, pressures, and power necessary to sustain a given work cycle. The study compares the results from a simulation of the excavator with actual test data obtained from a test vehicle taken during a typical work cycle.
Recommended Content
Journal Article | Modeling of Phase Change within a Wax Element Thermostat Embedded in an Automotive Cooling System |
Technical Paper | New Low Cost ABS Concept for Small Cars |
Authors
Citation
Siemens, M. and Larson, C., "Model to Predict Hydraulic Pump Requirements for an Off-Road Vehicle," SAE Technical Paper 901622, 1990, https://doi.org/10.4271/901622.Also In
References
- Haug, E. J. “Computer-Aided Kinematics and Dynamics of Mechanical Systems,” Allyn and Bacon Massachusetts 1989 51 52
- Sandor, G. N. Erdman A. G. “Advanced Mechanism Design: Analysis and Synthesis,” Prentice Hall Inc. New Jersey 1984 563 590
- Shigley, J. E. Unzicker J. J. “Theory of Machines and Mechanisms,” McGraw-Hill Book Co. New York 1980 175 176
- Cheney, W. Kincaid D. “Numerical Mathematics and Computing,” Brooks/Cole Publishing Company 1989 147 160