This content is not included in your SAE MOBILUS subscription, or you are not logged in.
A Simulation Model for Transient Operation of Spark-Ignition Engines
ISSN: 0148-7191, e-ISSN: 2688-3627
Published February 01, 1990 by SAE International in United States
Annotation ability available
A generalized computer model for analysis of multicylinder spark-ignition engines under transient conditions is presented. The model utilizes a two-zone combustion submodel based on flame propagation. It accounts for heat transfer and uses a chemical-kinetics-based procedure for the prediction of nitric oxide and carbon monoxide concentrations. Non-linear wave interactions in the exhaust and intake manifolds are considered. For the transient analysis, a vehicle model is coupled to the engine via a geartrain.
The model was used to predict the behavior of two four-cylinder engines under a variety of transient operating conditions. The simulation enabled systematic analysis of the interaction between various dynamic, thermodynamic, and emission variables under transient operating conditions of the engines. Results obtained from the program indicate that the model can closely capture the transient behavior of an engine, making it a convenient analytical tool for the analysis of dynamically-operated engines.
CitationBaruah, P., "A Simulation Model for Transient Operation of Spark-Ignition Engines," SAE Technical Paper 900682, 1990, https://doi.org/10.4271/900682.
- Waters, W. C., “General Purpose Automotive Vehicle Performance and Economy Simulator,” SAE Paper No. 720043, 1972.
- Blumberg, P. N., “Powertrain Simulation: A Tool for the Design and Evaluation of Engine Control Strategies in Vehicles,” SAE Paper No. 760158, 1976.
- DeLosh, R. G., Brewer, K. J., Buch, L. H., Ferguson, T. F. W., and Tobler, W. E., “Dynamic Computer Simulation of a Vehicle with Electronic Engine Control,” SAE Paper No. 810447, 1981.
- Finlay, I. C., Boam, D. J., Martins, J. J. G., Gilchrist, A., and Lee, C. K., “Models for Predicting Engine Torque Response During Rapid Throttle Transients in Spark-Ignition Engines,” Computers in Design, Construction and Operation of Automobiles, 1st International Conference on Computer Aided Design, Manufacture and Operation in the Automotive Industries, Computational Mech. Inst., Southampton, England, March 10-12, 1987.
- Dobner, D. J., “A Mathematical Engine Model for Development of Dynamic Engine Control,” SAE Paper No. 800054, 1980.
- Dobner, D. J., “Dynamic Engine Models for Control Development - Part I: Non-linear and Linear Model Formulation,” Int. J. of Vehicle Design, Special Publications SP4, 1983.
- Hong, C. W. and Watson, N., “Turbocharged S.I. Engine Simulation Under Steady and Transient Conditions,” SAE Paper No. 880122, 1988.
- Morris, R. L., Hopkins, H. G., and Borcherts, R. H., “An Identification Approach to Throttle-Torque Modeling,” SAE Paper No. 810448, also SAE-SP-487, 1981.
- Powell, B. K., Lawson, G. P., and Hogh, G., “Advanced Real Time Powertrain Systems Analysis,” ASME Paper 87-ICE-46, presented at the Energy-Sources Technology Conference and Exhibition, Dallas, Texas, February 15-20, 1987.
- Benson, R. S., Annand, W. J. D., and Baruah, P. C., “A Simulation Model Including Intake and Exhaust Systems for a Single Cylinder Four-Stroke Cycle Spark Ignition Engine,” Int. J. Mech. Science, Vol. 17, 1975, pp. 97-124.
- Benson, R. S., “The Thermodynamics and Gas Dynamics of Internal Combustion Engines,” Vol. I, Oxford University Press, 1982.
- Horlock, J. H. and Winterbone, D. E. W., “The Thermodynamics and Gas Dynamics of Internal Combustion Engines,” Vol. II, Oxford University Press, 1986.
- Groff, E. G. and Matekunas, F. A., “The Nature of Turbulent Flame Propagation in a Homogeneous Spark-Ignited Engine,” SAE Paper No. 800133, 1980.
- Thomson, M. W., Frelund, A. R., Pallas, M., and Miller, K. D., “General Motors 2.3L Quad 4 Engine,” SAE Paper No. 870353, 1987.
- Shindo, Y., Ito, H., and Ishihara, T., “A Fundamental Consideration on Shift Mechanism of Automatic Transmission,” SAE Paper No. 790043, 1979.
- Aquino, C. F., “Transient A/F Control Characteristics of the 5 Liter Central Fuel Injection Engine,” SAE Paper No. 810494, 1981.
- Hamburg, D. R. and Klick, D., “The Measurement and Improvement of the Transient A/F Characteristics of an Electronic Fuel Injection System,” SAE Paper No. 820766, 1982.
- Fozo, S. R. and Aquino, C. F., “Transient A/F Characteristics for Cold Operation of a 1.6 Liter Engine with Sequential Fuel Injection,” SAE Paper No. 880691, 1988.
- Ando, T., Minoura, M., and Ito, S., “A Study of Fuel Transport Delay in Intake Manifold and A/F Compensation Strategy,” JSAE Review, Vol. 8, No. 1, January 1987.