This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Development of a Fuel Injected Two-Stroke Gasoline Engine
Annotation ability available
Sector:
Language:
English
Abstract
AVL's development of a semi-direct injected two-stroke engine employed a carburetted 250cc production motorcycle engine as a baseline. Special emphasis vas placed on the investigation of fuel jet and scavenge flow interactions. To evaluate the scavenge flow pattern, a steady flow test procedure was developed and applied. The results of scavenging system optimization were confirmed by subsequent engine tests which showed significant gains in power output.
Completion of the first phase of the research program resulted in the development of a semi-direct injection system using currently available automotive low pressure manifold injection system components. Compared to the original carburetted engine, significant improvanents were demonstrated, including a 30% reduction of fuel consumption, a reduction of up to 60% in hydrocarbon emissions and up to 70% in carbon monoxide emission, averaged over the engine's speed and load range. Engine BMEP and power characteristics were maintained and improved. In addition, the critical idle operating conditions were improved significantly by stabilizing the combustion whith minimized cyclic variations.
The results of thermodynamic cycle analyses, based both on engine test measurements and on calculations, are presented.
Finally, the paper compares the semi-direct and direct injection systems and presents an outlook based on some of the results of the current phase of AVL's low emission two-stroke engine research program.
Recommended Content
Authors
Topic
Citation
Plohberger, D., Mikulic, L., and Landfahrer, K., "Development of a Fuel Injected Two-Stroke Gasoline Engine," SAE Technical Paper 880170, 1988, https://doi.org/10.4271/880170.Also In
References
- Oschatz, W. “Kraftstoffaufbereitung durch die Einspritzdüse” Deutsche Kraftfahrtforschung, Heft 57 VDI Verlag Berlin 1941
- Friedel. “Gemischbildung und Düsenentwicklung am Ein-spritz-Zündermotor; II. Bericht, Die Wirkung von Luftströmen auf Kraftstoffstrahlen” Deutsche Luftfahrtforschung, Untersuchungen und Mitteilungen Nr. 6936 Dresden 1944
- Rothrock, A. M. Spencer R. C. “Effect of Moderate Air flow on Fuel Sprays after Injection Cut Off” Report National Committee for Aeronautics No. 483 1933
- Bianchi, L. “Bombenversuche über Gemischbildung und Verbrennung bei Benzineinspritzung” Deutsche Kraftfahrtforschung, Zwischenbericht Nr. 94 1941
- Kühl, H. “Grundlagen der Gemischregelung beim Einspritz-Ottomotor mit Durchspülung” Deutsche Luftfahrtforschung, Forschungsbericht Nr. 1546 1942
- Augustin, U. “Die Einspritzung von Leichtkraftstoffen in Flugmotoren” ATZ 47 1944 3/4 30
- Brook, K. Nicolls “Some Aspects of Petrol-Injections” Equipment Developments 1947/48
- Campbell, J. F. “Fuel Injection as Applied to Aircraft Engines” SAE Journal 36 1935 77
- Dollinger “Untersuchungen an einem Zweitaktmotor mit Kraftstoffeinspritzung” Deutsche Kraftfahrtforschung, Zwischenbericht Nr. 9
- Schmidt, U. Froede W. “Zweitaktmotoren mit Benzineinspritzung” Deutsche Kraftfahrtforschung, Zwischenbericht Nr. 68 1938
- Morghen, K. “Die Energieumsetzung im Zweitakt-Otto-motor mit Umkehrspülung bei Benzineinspritzung” Deutsche Luftfahrtforschung, Forschungsbericht Nr. 1688 1942
- Morghen, K. “Die Energieumsetzung im Zweitakt-Otto-motor bei Benzineinspritzung” ZWB Forschungsbericht Nr. 1740 1942
- Froede, W. “Sonderfragen der Benzineinspritzung” Deutsche Kraftfahrtforschung, Zwischenbericht Nr. 363 1940
- Scherenberg, H. “Rückblick über 25 Jahre Benzin-Einspritzung in Deutschland” MTZ 16 9 September 1955
- Voit, W. Stoll, H. “Benzineinspritzung am Fahrzeug-Ottomotor” MEZ 13 9 September 1952
- Froede, W. “Benzineinspritzung für kleine Zylinder von Ottomotoren” MIZ 57 8 August 1955
- “Zweitakteinspritzung bei Gutbrod und Goliath” MTZ 13 10 Oktober 1952
- Groth, K. “Das Betriebsverhalten des schnellaufenden Zwei taktottonetors mit Einspritzung und seine Ent-wicklungsmöglichkeiten” Deutsche Kraftfahrtforschung und Straβenverkehrstechnik 1959
- Kuentscher, V. “Application of Charge Stratification, Lean Bum Combustion Systems and Anti-Knock Control Devices in small Two Stroke Cycle Gasoline Engines” SAE Paper 860171 1986
- Kuentscher, V. “Ladungsschichtung und Hagerkonzept-Verbrennung ira Zweitakt-Ottomotor mit elektronisch gesteuerter Druckstoβeinspritzung” Wissenschaftliche Beiträge der IH Zwickau 10 1984
- Nuti, R. “Direct Fuel Injection: An Opportunity for Two-Stroke SI Engines in Road Vehicle use” SAE Paper 860170 1986
- Vieilledent, E. “Low Pressure Fuel Injection System for Two-Stroke Engines” SAE Paper 780767 1987
- Douglas, R. Blair, G.P. “Fuel Injection of a Two-Stroke Cycle Spark Ignition Engine” SAE Paper 820952 1982
- Grasas-Alsina, C. et al. “Low Pressure discontinous Gasoline Injection in Two-Stroke Engines” SAE Paper 860168 1986
- Bizjan, F. Pavletic, R. “The Nozzle Location and the Shape of Its Surroundings in the Cylinder of Small Two-Stroke Engine'” SAE Paper 860169 1986
- List, H. Niedermayer, E. “Versuche an der Zweitakt-dieselmaschine” Forschung auf den Gebiete des In-genieurwesens Band 8 Berlin 1937
- Niedermayer, E. “Zusammenhänge zwischen Ladungswechsel und Leistung beim Zweitaktmotor” MIZ 1941
- Niedermayer, E. “Untersuchung des Spülvorganges an Zweitaktdieselraaschinen” Forschung auf dem Gebiete des Ingenieurwesens (VDI) 1936
- Hold, P. “Untersuchungen von Spülsystemen an der zündenden Zweitaktmaschine” MIZ 1940
- Blair, G.P. Kenny, R.G. “Further Developments in Scavenging Analysis for Two-Cycle Engines” SAE Paper 800038 1980
- Nuti, H. Martorano, L. “Short-Circuit Ratio Evaluation in the Scavenging of Two-Stroke SI Engines” SAE Paper 850177 1985
- Endres, W. Danner, M. “Spülluft, Verbrennungsgase und Mischzone im Zylinder des Zweitaktmotors” MTZ 1959
- Ohigashi, S. “Spüulvorgang bei Zweitaktmotoren mit um-kehrspülung” HTZ 1959
- Sanborn, D.S. Blair, G.P. et al. “Experimental Assessment of Scavenging Efficiency of Two-Stroke Cycle Engines” SAE Paper 800975 1980
- Sanborn, D.S. Roeder, W.M. “Single Cycle Simulation Simplifies Scavenging Study” SAE Paper 850175 1985
- Sweeney, Kenny Swann, Blair “Single Cycle Gas Testing Method for Two-Stroke Engine Scavenging” SAE Paper 850178 1985
- Jante, A. “Scavenging and Other Problems of Two-Stroke Cycle Spark-Ignition Engines” SAE Paper 680468 1968
- Blair, G.P. “Studying Scavenge Flow in a Two-stroke Cycle Engine” SAE Paper 750752 1975
- Jaros, K. “Eine neue Methode zur Bemessung und Bewertung der Spülvorgänge bei Zweitaktmotoren” Kraftfahrzeugtechnik Heft 6 Berlin 1986
- Blair, G.P. Ashe M.C. “The Unsteady Gas Exchange Characteristics of a Two-Cycle Engine” SAE-Paper 760644 1976
- Munoz, H. et al. “Two-Stroke Engines-Models for Charge Renovation” SAE-Paper 850084 1985
- Forschungsvereinigung Verbrennungskraftmaschinen e.V. “Beschreibung des Prograransystans PROMO)” Forschungsberichte 1977
- Becker, K. et al. “Umweltproblere bei motorisierten Zweirädem” Kontakt und Studium Band 119 Expert Verlag BRD 1984