This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Influence of Micro Surface Structures of Nodular Cast Iron Crankshafts on Plain Bearing Wear
Annotation ability available
Sector:
Language:
English
Abstract
Passenger car engines have been equipped with cast crankshafts since 1950. However, their use as opposed to the steel counterparts does increase the wear rate of plain bearings. If the surface finishing operation carried out on nodular cast iron leaves an unsuitable surface texture, the bearing is likely to suffer extensive wear.
Previous research examined the effect of different machining methods on the wear behaviour of three-layer high-strength bearings. Unfortunately, it did not prove possible to complete a thorough, systematic investigation of the effects of all the individual factors, even using sophisticated diesel engine tests, since the parameters concerned are too closely interrelated to be isolated.
It was aimed at developing a straightforward and financially feasible test procedure to determine the wear mechanism operating in the semi-fluid friction region. The principles underlying the observed increase in wear on bearings could be traced back quite clearly to the specific surface machining method employed in the manufacture of the crankshaft. The cutting quality during the final machining stage by micro-finishing of pins proved to be of importance. A process was devised which guarantees a considerable reduction in wear compared with that encountered currently in normal OEM. Since completion of the test bench work, engine tests have confirmed the findings and every reason is seen to believe that the method, once suitably modified, will be adopted by engine manufacturers for volume manufactoring.
Recommended Content
Topic
Citation
Engel, U., Staudinger, H., and Reuter, M., "Influence of Micro Surface Structures of Nodular Cast Iron Crankshafts on Plain Bearing Wear," SAE Technical Paper 880097, 1988, https://doi.org/10.4271/880097.Also In
References
- Gegossene Krause R. Kurbelwellen, konstruktive und werkstoffliche Möglichkeiten für den Einsatz in modernen Personenwagenmotoren Motortechnische Zeitschrift
- Sonnenschein T. Trapp H. G. Walter H. Gegossene Kurbelwellen Motortechnische Zeitschrift
- Manning F. Trapp H.G. Walter H. Schwingfestigkeit und Betriebsfestigkeit gegossener Fahrzeugteile Sonderdruck 1981
- Albrecht K.H. Emanuel H. Junk H. Optimierung von Kurbelwellen aus Gußeisen mit Kugelgraphit Motortechnische Zeitschrift
- VDA-Statistik, Mitteilungen des Verbandes der deutschen Automobllindustrie Januar 1987
- Roemer E. Die Oberfiäche von Lagerzapfen aus Grauguß und Kugel-graphitguß Glyco-Metall-Werke Ingenieur-Bericht
- Siegel B. Ruhstorfer F. Piesslinger S. Elektrolytisches Polieren und Entgraten von Sphäroguß Bericht der Fa. Poligrat München 1968-1973
- Schopf E. Untersuchung des Werkstoffeinflusses auf die Freßemp-findlichkeit von Gleitlagem Dissertation Universität Karlsruhe