This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Enhanced Tapered Roller Bearing Performance
Technical Paper
871211
Annotation ability available
Sector:
Language:
English
Abstract
Tapered roller bearing performance has been enhanced through significant advances in bearing design, material quality, and manufacturing technology. These advances were made possible by the development of analysis methods and testing that pinpoint specific areas for improvement. As a result, maximum bearing performance can be achieved in smaller bearing designs or increased reliability can be realised within existing bearing sizes. Automotive and industrial designers have the opportunity to improve bearing application performance while accomplishing other objectives of lower weight and lower cost.
Recommended Content
Technical Paper | Tapered Roller Bearing Performance for 1990's |
Technical Paper | Design Target and Life Cycle Cost Management Through Bearing Value Analysis |
Technical Paper | Trials and Tribulations of Fatigue Testing of Bearings |
Topic
Citation
Nixon, H. and Mover, C., "Enhanced Tapered Roller Bearing Performance," SAE Technical Paper 871211, 1987.Also In
References
- Widner, R. L. Littmann, W. E. “Bearing Damage Analysis” Nat. Bureau of Standards Mechanical Failure - Definition of the Problem Proceedings Mech Failures Prev. Group Gaithersburg Md May 8-10 1974 67 84 1976
- Darragh, C. V. “A Method for Bearing Damage Analysis” SAE Technical Paper Series 320634 1982
- Cave, B. J. Mitchell, C. J. “Bearing Systems Analysis” The Institution of Engineers Australia National Conference Publication No. 80/2
- Dominik, W. E. “Rating and Life Formulas For Tapered Roller Bearings” SAE Technical Paper Series 841121 1984
- _____ Bearing Selection Handbook Revised - 1986 The Timken Company Canton Ohio, U.S.A. 1986
- Stover, J. D. Kolarik, R. V. “Air-Melted Steel with Ultra-Low Inclusion Stringer Content Further improves Bearing Fatigue Life” presented at the International Pacific Conference on Automotive Engineering SAE Melbourne Australia Nov. 1987
- Hoeprich, M. R. “Numerical Procedure for Designing Rolling Element Contact Geometry as a Function of Load Cycle” SAE Technical Paper Series 850764 1985
- Wymer, D. F. Cameron, A. “Elastohydrodynamic Lubrication of a Line Contact” Proceedings I. Mech. Eng. 188 19 1974
- Danner, C. H. “Fatigue Life of Tapered Roller Bearings Under Minimal Lubricant Films,” ASLE Trans. 13 4 241 251 1970
- Moyer, C. A. “Lubricant Variation Effect on Tapered Roller Bearing Fatigue Life” presented ASLE Annual meeting May 11-14 1987 Anaheim Calif.
- Strong, S. R. Fahrni, G. R. “Selecting Bearings Without A Catalog” SAE Technical Paper Series 851510 1985 International Off-highway & Power Plant Congress and Exposition Milwaukee, WI Sept. 1985