This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Measurement of the Rolling Element Load Distribution in Turntable Bearings
Annotation ability available
Sector:
Language:
English
Abstract
This paper presents a method of measuring rolling element loads within large size ball bearings of four-point contact configuration. The rolling element loads are measured with an original method under five fastened conditions for a turntable bearing. The rolling element load distribution is obtained, and the results are compared to the computed loads and distributions.
Recommended Content
Technical Paper | Footprint Analysis of Rolling Element Bearings |
Technical Paper | A Standardized Method for Evaluating Debris Resistance of Rolling Element Bearings |
Ground Vehicle Standard | Automotive V-Belt Drives |
Citation
Takahashi, H. and Omory, T., "Measurement of the Rolling Element Load Distribution in Turntable Bearings," SAE Technical Paper 850762, 1985, https://doi.org/10.4271/850762.Also In
References
- Mckenzie H. PE Arnold J. “Footprint Analysis of Rolling Element Bearings” S.A.E. Paper Nov. 18 1982
- Goodelle R. A. Derner W. J. Root L. W. “Determination of Static Load Distributions from Elastic in Rolling Element Bearings” ASLE Paper 1971
- Goodelle R. A. Derner W. J. Root L. E, “A Practical Method for Determing Contact Stresses in Elastically Loaded Line Contacts” ASLE Paper 1970
- Kashino N. Ishimaru M. “The Design, Durability and Performance of the Turntable Bearing for a Small Truke Crane” S.A.E. Paper 831369 Sept. 12-15 1983