This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Interlaboratory Rolling Resistance Testing - Highway Truck and Bus Tires
Annotation ability available
Sector:
Language:
English
Abstract
A cooperative round robin test program was initiated among various test facilities in order to validate the procedure specified in the proposed SAE Recommended Practice for the measurement of rolling resistance of highway truck and bus tires. After suitable corrections were made for test drum size and for ambient temperature, the data from all the facilities were found to be clustered about the mean. Where multiple runs were made by a single facility, run to run variability was examined and found to be quite low. It was concluded that consistent rolling resistance data on highway truck and bus tires can be obtained on a variety of indoor test equipment. The conclusions apply if the procedures in the SAE Recommended Practice J1379 and accompanying Information Report J1380 are followed, and suitable correction factors are used.
Recommended Content
Ground Vehicle Standard | Measurement of Passenger Car, Light Truck, and Highway Truck and Bus Tire Rolling Resistance |
Ground Vehicle Standard | Rolling Resistance Measurement Procedure for Passenger Car, Light Truck, and Highway Truck and Bus Tires |
Technical Paper | Road Contact Forces of Truck Tires as Measured in the Laboratory |
Authors
Citation
O'Neal, J., Brunot, C., Wanstedt, A., and Warholic, T., "Interlaboratory Rolling Resistance Testing - Highway Truck and Bus Tires," SAE Technical Paper 821265, 1982, https://doi.org/10.4271/821265.Also In
References
- Clark S. K. Schuring, D. J. “Inter-laboratory Tests of Tire Rolling Resistance” SAE paper 780636 June 1978
- SAE Recommended Practice “Rolling Resistance Measurements for Passenger Car Tires” SAE J1269 November 1979
- SAE Information Report “The Measurement of Passenger Car Tire Rolling Resistance” SAE J1270 October 1979
- SAE Recommended Practice “Rolling Resistance Measurement Procedure for Highway Truck and Bus Tires” SAE J1379
- SAE Information Report “The Measurement of Highway Truck and Bus Tire Rolling Resistance” SAE J1380
- Bogdan L. Rice, R. “Laboratory and Full Scale Parametric Studies of the Rolling Resistance of Radial and Bias-Ply Heavy Service Truck Tires” U.S. Department of Transportation Calspan Report No. 6278-T November 1980
- Schuring D. J. Hall, G. L. “Ambient Temperature Effects on Tire Rolling Loss” Rubber Chemistry and Technology Volume 54 No. 5 1113 1123 November–December 1981
- Clark, S. K. “Rolling Resistance Forces in Pneumatic Tires” U.S. Department of Transportation TSC Report No. DOT-TSC-76-1 January 1976
- Luchini, J. R. “Test Surface Curvature Reduction Factor for Truck Tire Rolling Resistance” SAE paper 821264 November 1982