This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Thickness Effects on Material Properties in a Glass/Thermoplastic P.E.T. Injection Molding Compound
Annotation ability available
Sector:
Language:
English
Abstract
Rynite®* 545, a commercial short glass fiber/thermoplastic polyethylene terepthalate system, was injection molded into end-gated rectangular plaques of various thicknesses. The plaques were sectioned and characterized by scanning electron microscopy and by mechanical and thermal expansion tests. The glass fibers are shown to be highly aligned in “boundary layers” near the mold surfaces, and are distributed more randomly away from the mold surfaces. As part thickness increased, the aligned fiber boundary layers occupied a smaller proportion of the cross section, resulting in a decrease in mechanical properties. Tensile moduli are derived for boundary and center layers, which can be used to accurately predict the effective moduli at different thicknesses. In addition, the boundary layer thicknesses at the top and bottom surfaces were unequal, producing noticeable warping for thicker plaques.
Authors
Citation
Wetherhold, R., Dick, W., and Pipes, R., "Thickness Effects on Material Properties in a Glass/Thermoplastic P.E.T. Injection Molding Compound," SAE Technical Paper 800812, 1980, https://doi.org/10.4271/800812.Also In
References
- Taggart D. G. Pipes R. B. Mosko J. C. “Test Method Evaluation for Fiber-Reinforced Molding Materials,” Polymer Engineering and Science
- Wu C. D. T. McCullough R. L. “Constitutive Relationships for Heterogeneous Materials,” Developments in Composite Materials 1 1977 119 187
- Pagano N. J. Halpin J. C. “Influence of End Constraint in the Testing of Anisotropic Bodies,” Journal of Composite Materials 2 1 January 1968 18 31