This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
The Oscillations of a Flexible Castor, and the Effect of Front Fork Flexibility on the Stability of Motorcycles
Annotation ability available
Sector:
Language:
English
Abstract
Castor oscillations are of prime importance in many situations, from the simple tea-trolley to towed vehicles, the landing wheels of aircraft, and the motorcycle instability problem of ‘speed wobbles’. This paper sets out a mechanism of castor instability based on the lateral flexibility in the wheel support. In the case of a motorcycle this is the flexibility in the front fork/wheel system.
For small amplitude oscillations the equations of motion are shown to be coupled ordinary differential equations which contain terms representing a relay switching function. These equations are solved numerically for many parameter variations. Close agreement is obtained with observed amplitudes and frequencies, and with the oscillation characteristics. For certain sets of parameters the numerical solutions are also found to agree well with the predicted solutions obtained using an analytic technique.
From the results it is very clear that the most important parameter affecting stability is lateral stiffness, and a new motorcycle front fork of high lateral stiffness is described. This fork has already achieved success on the road, test track and race track.
Recommended Content
| Technical Paper | Experimental Investigation of the Transient Behavior of Motorcycles |
| Technical Paper | Motorcycle Instability on Undulating Road Surfaces |
Authors
Citation
Roe, G., Pickering, W., and Zinober, A., "The Oscillations of a Flexible Castor, and the Effect of Front Fork Flexibility on the Stability of Motorcycles," SAE Technical Paper 780307, 1978, https://doi.org/10.4271/780307.Also In
References
- Roe G.E. Thorpe T.E. “A solution of the low-speed wheel flutter instability in motorcycles” J.Mech.Eng.Sci. 18 2 57 1976
- Kantrowitz A. “Stability of castoring wheels for aircraft landing gears” Tech.Notes Nat.Advis.Comm.Aeronaut. Wash 686 1940
- Pacejka H.B. “Analysis of shimmy phenomenon” Proci.I.Mech.E. 180 2A 251 1966
- Roe G.E. “Theory of castor oscillations” J.Mech.Eng.Sci. 15 5 379 1973 17 1 42 1975
- Roe G.E. Thorpe T.E. “Experimental investigation of the parameters affecting the castor stability of road wheels” J.Mech.Eng.Sci. 15 5 365 1973
- Sharp R.S. “The stability and control of motorcyles” J.Mech.Eng.Sci. 13 5 316 1971
- Sharp R.S. “Research Note: The influence of frame flexibility on the lateral stability of motorcycles” J.Mech.Eng.Sci. 16 2 117 1974
- Flügge-Lotz I. “Discontinuous automatic control” New Jersey Princeton University Press 1953
- André J. Seibert P. 7 148 1956
- Anderson B.D.O. Moore J.B. “Linear optimal control” Prentice-Hall 99 1971
- Gelb A. van der Velde W. “Multiple-input describing functions and non-linear system design.” McGraw-Hill 1968
- Truxall J.G. “Automatic feedback control system synthesis” McGraw-Hill 1955
- Kochenburger R.J. “A frequency response method of analysing and synthesising contactor servomechanisms” Trans.Amer.Inst.Elect.Engrs 69 270 1950
- Tsypkin Ya. Z. “Theory of relay systems in automatic control” Moscow 1958
- Gille J.C. Pélgerin M.J. Decaulne P. “Feedback control systems” McGraw-Hill 1959