This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Analysis and Prediction of Engine Structure Vibration
Annotation ability available
Sector:
Language:
English
Abstract
The work described in this paper was undertaken as part of a program aimed at predicting engine noise and vibration characteristics at the design stage.
The initial work was carried out on simplified two dimensional plate structures and a simple three dimensional model. Surface vibration and noise levels were predicted and compared with measured vibration levels and mode shapes are given for an in-line six cylinder diesel engine.
The prediction of noise at the design stage relies upon the calculation of surface response levels. Supplementary tests on engine components to determine damping are reported. The approach to Force level simulation over a broad frequency band is also considered.
Recommended Content
Authors
Citation
Hawkins, M. and Southall, R., "Analysis and Prediction of Engine Structure Vibration," SAE Technical Paper 750832, 1975, https://doi.org/10.4271/750832.Also In
References
- Hawkins M.G. O'keeffe J.M. ‘A Method of Determining the Effect of Design Change on Diesel Engine Noise.’ C.I.M.A.C. 1975
- Yorke P.J. ‘The Application of Idealisation and Response Analysis to Diesel Engine Noise Assessment’ SAE Off Highway Vehicle Meeting September 1975
- Russell M.F. ‘Automotive Diesel Engine Noise and its Control.’ SAE International Automotive Engineering Congress Detroit January 1973
- Chan C.M.P. Anderton D. ‘The Correlation of Machine Structure Surface and Vibration and Radiated Noise’ Inter Noise 72 Proc. October 1972
- Seybert A.F. ‘Estimation of Contributed Noise Levels of Diesel Engine Components from Vibration Measurements’ Automotive Engineering Congress and Exposition Detroit February 1975
- Wallace ‘Radiation Resistance of a Rectangular Plate’ J.A.S.A. 51 3 1972 946 952
- Kennedy Pancu ‘Use of Vectors in Vibration Measurement and Analysis’ Aeron J. Roy SOC. 14,603 1947
- Szchenyi ‘Approximate Methods for Determination of Natural frequencies and Normal Modes of Stiffened flat and curved Plates’ Conference at the University of Southampton 6 9 July 1970
- Warburton G.B. ‘The Vibration of Rectangular Plates’ Proc. Inst. Mech. Eng. 168 371 384 1954
- Zienkiewicz ‘The finite Element Method in Science and Engineering’ McGraw-Hill 1971
- Henshell P.D. ‘Pafec 70+’ Nottingham University 1972
- MacNeal - Schwendler Corporation - Nastran Manual. N.A.S.A.